1 September 2022 in Environmental Science & Technology
Accurate determination of acidity (pH) and ion activities in aqueous droplets is a major experimental and theoretical challenge for understanding and simulating atmospheric multiphase chemistry. Here, we develop a ratiometric Raman spectroscopy method to measure the equilibrium concentration of sulfate (SO42-) and bisulfate (HSO4-) in single microdroplets levitated by aerosol optical tweezers. This approach enables determination of ion activities and pH in aqueous sodium bisulfate droplets under highly supersaturated conditions. The experimental results were compared against aerosol thermodynamic model calculations in terms of simulating aerosol ion concentrations, ion activity coefficients, and pH. We found that the Extended Aerosol Inorganics Model (E-AIM) can well reproduce the experimental results. The alternative model ISORROPIA, however, exhibits substantial deviations in SO42- and HSO4- concentrations and up to a full unit of aerosol pH under acidic conditions, mainly due to discrepancies in simulating ion activity coefficients of SO42--HSO4- equilibrium. Globally, this may cause an average deviation of ISORROPIA from E-AIM by 25 and 65% in predicting SO42- and HSO4- concentrations, respectively. Our results show that it is important to determine aerosol pH and ion activities in the investigation of sulfate formation and related aqueous phase chemistry.
3 October 2023 in Journal of the American Chemical Society
The chemistry of pyruvic acid (PA) under thermal dark conditions is limited in bulk solutions, but in microdroplets it is shown to readily occur. Utilizing in situ micro-Raman spectroscopy as a probe, we investigated the chemistry of PA within aqueous microdroplets in a relative humidity- and temperature-controlled environmental cell. We found that PA undergoes a condensation reaction to yield mostly zymonic acid. Interestingly, the reaction follows a size-dependent sigmoidal kinetic profile, i.e., an induction period followed by reaction and then completion. The induction time is linearly proportional to the surface area (R2), and the maximum apparent reaction rate is proportional to the surface-to-volume ratio (1/R), showing that both the induction and reaction occur at the air-water interface. Furthermore, the droplet size is shown to be dynamic due to changes in droplet composition and re-equilibration with the relative humidity within the environmental cell as the reaction proceeds. Overall, the size-dependent sigmoidal kinetics, shown for the first time in microdroplets, demonstrates the complexity of the reaction mechanism and the importance of the air-water interface in the pyruvic acid condensation reaction.
18 July 2024 in Chemical Science
Although aqueous microdroplets have been shown to exhibit enhanced chemical reactivity compared to bulk solutions, mechanisms for these enhancements are not completely understood. Here we combine experimental measurements and kinetic modeling to show the strong coupling of interfacial reactions and gas/droplet partitioning in the condensation reaction of pyruvic acid (PA) to yield zymonic acid (ZA) in acidic aqueous microdroplets. Experimental analysis of single microdroplets reveals the substantial influence of evaporation of PA and partitioning of water on the size-, relative humidity (RH)- and temperature-dependent sigmoidal reaction kinetics for the condensation reaction. A newly developed diffusion–reaction–partitioning model is used to simulate the complex kinetics observed in the microdroplets. The model can quantitatively predict the size and compositional changes as the reaction proceeds under different environmental conditions, and provides insights into how microdroplet reactivity is controlled by coupled interfacial reactions and the gas-phase partitioning of PA and water. Importantly, the kinetic model best fits the data when an autocatalytic step is included in the mechanism, i.e. a reaction step where the product, ZA, catalyzes the interfacial condensation reaction. Overall, the dynamic nature of aqueous microdroplet chemistry and the coupling of interfacial chemistry with gas-phase partitioning are demonstrated. Furthermore, autocatalysis of small organic molecules at the air–water interface for aqueous microdroplets, shown here for the first time, has implications for several fields including prebiotic chemistry, atmospheric chemistry and chemical synthesis.
13 November 2020 in Atmospheric Measurement Techniques
Direct measurement of the acidity (pH) of ambient aerosol particles/droplets has long been a challenge for atmospheric scientists. A novel and facile method was introduced recently by Craig et al. (2018), where the pH of size-resolved aerosol droplets was directly measured by two types of pH-indicator papers (pH ranges: 0–2.5 and 2.5–4.5) combined with RGB-based colorimetric analyses using a model of G−B (G minus B) vs. pH2. Given the wide pH range of ambient aerosols, we optimize the RGB-based colorimetric analysis on pH papers with a wider detection range (pH ∼ 0 to 6). Here, we propose a new model to establish the linear relationship between RGB values and pH: pHpredict = . This model shows a wider applicability and higher accuracy than those in previous studies and is thus recommended in future RGB-based colorimetric analyses on pH papers. Moreover, we identify one type of pH paper (Hydrion® Brilliant pH dip stiks, lot no. 3110, Sigma-Aldrich) that is more applicable for ambient aerosols in terms of its wide pH detection range (0 to 6) and strong anti-interference capacity. Custom-made impactors are used to collect lab-generated aerosols on this type of pH paper. Preliminary tests show that, with a collected particle size range of ∼ 0.4–2.2 µm, the pH paper method can be used to predict aerosol pH with an overall uncertainty ≤ 0.5 units. Based on laboratory tests, a relatively short sampling time (∼ 1 to 4 h) is speculated for pH prediction of ambient aerosols. More importantly, our design of the impactors minimizes potential influences of changed environmental conditions during pH paper photographing processes on the predicted aerosol pH. We further show that the routinely adopted way of using pH color charts to predict aerosol pH may be biased by the mismatch between the standard colors on the color charts and the real colors of investigated samples. Thus, instead of using the producer-provided color charts, we suggest an in situ calibration of pH papers with standard pH buffers.
20 June 2024 in Environmental Science & Technology