1 January 2017 in Sensors and Actuators B: Chemical
27 March 2020 in Nanotechnology
We demonstrate the HfSe 2 saturable absorber (SA) for the generation of ultrafast pulse laser. The HfSe 2 SA device is fabricated by integrating HfSe 2 nanosheets (NSs) with a microfiber. The material and optical characteristics of HfSe 2 NSs show their high quality. The nonlinear optical absorption of HfSe 2 SA is measured with a modulation depth of 5.8%. Stable soliton mode-locked laser based on HfSe 2 SA is realized at the central wavelength of 1561.43 nm with pulse duration of 297 fs and the maximum pulse energy of 2.68 nJ. Our soliton fiber laser has a maximum output power of 48.5 mW with a high slope efficiency of 12.8%, which indicate that HfSe 2 is a good candidate of SA for high efficient ultrashort pulses generation.
11 February 2022 in Optics Letters
We demonstrate a low-power, compact micro-ring phase shifter based on hybrid integration with atomically thin two-dimensional layered materials, and experimentally establish a low-loss silicon nitride platform. Using a wet transfer method, a large-area few-layer MoS2 film is hybrid integrated with a micro-ring phase shifter, leading to a tuning efficiency of 5.8 pm V−1 at a center wavelength of 1545.294 nm and a half-wave-voltage-length product as low as 0.09 V cm. Our device is designed to provide a hybrid-integration-based active phase modulation scheme for integrated optical communication networks with large-cross-section silicon nitride waveguides.
3 March 2020 in Journal of Lightwave Technology
Ultrafast fiber lasers with a wide spectral range have huge demands for many applications. In this paper, magnetron sputtering deposition (MSD) technique was utilized to prepare a new broadband microfiber based Sb thin film saturable absorbent (SA), and ultrafast pulses in both 1.5 and 2 μm wavebands were generated with the integrated microfiber-based Sb thin film SA in erbium-doped fiber laser (EDFL) and thulium-doped fiber laser (TDFL), respectively. Pulse duration of 544 fs / 972 fs and output power of 21.76 mW / 36.1 mW centered at 1557 nm / 1892 nm were respectively produced from stable mode-locked EDFL and TDFL. To the best our knowledge, this is the first time that ultrafast fiber lasers including both 1.5 μm and 2 μm wavebands were mode locked by a single microfiber-based Sb thin film SA.
27 June 2022 in Journal of Lightwave Technology
Benefitting from the excellent characteristics such as low cytotoxicity, functionalization versatility, and tunable fluorescence, nanodiamonds (NDs) have shown enormous application potentials in the biomedical field. Herein, we proposed, for the first time to our best knowledge, to integrate NDs on a plasmonic interface constructed on a side-polished fiber using drop-casting method. The NDs engineers the plasmonic interface towards improving the sensing field thus the sensitivity, which, moreover, is dependent on the number of drop-casting cycles (DCs) and the used concentration of NDs dispersion solution. Experimental results suggest that properly increasing the NDs dispersion concentration is beneficial to obtain a higher sensitivity while using a fewer number of DCs, but the excessive concentration extremely deteriorates the resonance dip. Using the 0.2 mg/mL concentration and 3 DCs, we achieve the highest RI sensitivity of 3582 nm/RIU, which shows an enhancement of 73.8% compared to the case without NDs modification. The sensitivity enhancement in biosensing is also proved by employing bovine serum albumin as a demo. The behind mechanism is explored via characterizations and simulations. This work opens up a new application form for NDs, i.e. integrating NDs with a plasmonic interface towards high-performance biosensing.
23 December 2019 in Applied Optics
A passively mode-locked thulium-doped fiber laser using a tungsten ditelluride saturable absorber ( ) is demonstrated. High-power mode-locked pulses with an average output power of 108.1 mW were achieved by incorporating the into a thulium-doped fiber oscillator. To the best of our knowledge, this is the highest average power obtained from a -based fiber laser. We further amplified the output power to 5.60 W with an all-fiber thulium-doped double-cladding fiber amplifier. Our result indicates that could be an excellent candidate for a high-power fiber laser system.