28 February 2022 in IEEE Transactions on Antennas and Propagation
Large bandwidth at millimeter wave (mm-wave) is crucial for fifth generation (5G) and beyond, but the high path loss (PL) requires highly accurate PL prediction for network planning and optimization. Statistical models with slope-intercept fit fall short in capturing large variations seen in urban canyons, whereas ray tracing, capable of characterizing site-specific features, faces challenges in describing foliage and street clutter and associated reflection/diffraction ray calculation. Machine learning (ML) is promising but faces three key challenges in PL prediction: 1) insufficient measurement data; 2) lack of extrapolation to new streets; 3) overwhelmingly complex features/models. We propose an ML-based urban canyon PL prediction model based on extensive 28 GHz measurements from Manhattan where street clutters are modeled via a light detection and ranging (LiDAR) point cloud dataset and buildings by a mesh-grid building dataset. We extract expert knowledge-driven street clutter features from the point cloud and aggressively compress the 3-D building information using a convolutional autoencoder. Using a new street-by-street training and testing procedure to improve generalizability, the proposed model using both clutter and building features achieves a prediction error [root-mean-square error (RMSE)] of 4.8 ± 1.1 dB compared to 10.6 ± 4.4 and 6.5 ± 2.0 dB for 3GPP line of sight (LOS) and slope-intercept prediction, respectively, where the standard deviation indicates street-by-street variation. By only using four most influential clutter features, the RMSE of 5.5 ± 1.1 dB is achieved.
27 March 2017 in IEEE Journal on Selected Areas in Communications
Delivering Gbps high user rate over long distances (~1 km) is challenging, and the abundant spectrum available in millimeter wave band cannot solve the challenge by its own due to the severe path loss and other limitations. Since it is economically challenging to deploy wired backhaul every few hundred meters, relays (e.g., wireless access points) have been proposed to extend the coverage of a base station, which has wired connection to the core network. These relays, deployed every few hundred meters, serve the users in their vicinity and are backhauled to the base station through wireless connections. In this paper, the wireless-relayed backhaul design has been formulated as a topology-bandwidth-power joint optimization problem, and the influence of path loss, angular spread, array size, and RF power limitation on the user rate has been evaluated. It has been shown that for a linear network deployed along the street at 28 GHz, when high joint directional gain (50 dBi) is available, 1 Gb/s user rate within cell range of 1 km can be delivered using 1.5 GHz of bandwidth (using single polarization antennas). The user rates drop precipitously when joint directional gain is reduced, or when the path loss is much more severe. When the number of RF chains is limited, the benefit of larger arrays will eventually be surpassed by the increased channel estimation penalty as the effective beamforming gain saturates owing to the channel angular spread.
14 February 2020 in IEEE Transactions on Antennas and Propagation
Adequate coverage with high gain antennas is key to realizing the full promise of the bandwidth available at mm/cm wave bands. We report extensive indoor measurements at 28 GHz (1000 links, 9.9 million individual power measurements, 10 offices, 2 buildings), with/without line-of-sight (LOS) using a continuous wave channel sounder, with a 10° spinning horn, capable of capturing a full azimuth scan every 200 ms, in up to 171 dB path loss to characterize coverage with 90% confidence level. The environment had prominent corridors and rooms, as opposed to open/mixed offices in latest 3GPP standards. Guiding in corridors leads to much lower RMS azimuth spread (7° median in corridor non-LOS vs. 42° in 3GPP) and higher penetration loss into rooms and around corners (30-32 dB, some 12 dB more loss than 3GPP at 20 m non-LOS). Measured path gain in non-LOS is predicted by a mode-diffusion model with 3.9 dB RMS error. Scattering degraded azimuth gain by up to 4 dB in the corridor and 7 dB in rooms with 90% probability. Link simulations in a canonical building indicate every corridor needs an access point to provide 1 Gbps rate to adjoining rooms within 50 m using 400 MHz of bandwidth.
27 April 2017 in IEEE Journal on Selected Areas in Communications
Great increase in wireless access rates might be attainable using the large amount of spectrum available in the millimeter wave (mmWave) band. However, higher propagation losses inherent in these frequencies must be addressed, especially at ranges beyond 100 meters and in non-line-of-sight (NLOS) settings. In contrast to the interference limited legacy cellular systems where using more bandwidth is favorable, , to use wider bandwidth for mmWave channels in noise limited settings may be ineffective or even counterproductive when accounting for channel estimation penalty. In this paper we quantify the maximum beneficial bandwidth for mmWave transmission in some typical deployment scenarios where pilot-based channel estimation penalty is taken into account assuming a minimum mean square error (MMSE) channel estimator at the receiver. We find that, under I.I.D. block fading model with coherence time Tc and coherence bandwidth Bc, for transmitters and receivers equipped with a single antenna, the optimal (rate maximizing) signal-to-noise-ratio (SNR) is a constant that only depends on the product BcTc, which measures the channel coherence and equals the average number of orthogonal symbols per each independent channel coefficient. That is, for fixed channel coherence BcTc, the optimal bandwidth scales linearly with the received signal power. Under 3GPP Urban Micro NLOS path loss model with coherence time Tc = 5 ms and coherence bandwidth Bc = 10 MHz, using 52 dBm Equivalent Isotropic Radiated Power (EIRP) at the transmitter and 11 dBi antenna gain at the receiver, the maximum beneficial bandwidth at 28 (resp. 39) GHz is less than 1 GHz at a distance beyond 210 (resp. 170) meters with maximum throughput about 200 Mbps, and less than 100 MHz beyond 400 (resp. 310) meters with maximum throughput about 20 Mbps. At EIRP of 85 dBm, corresponding to the FCC limit of 75 dBm per 100 MHz, 1 Gbps rate can be delivered using 1 GHz bandwidth up to 860 (resp. 680) meters.
6 November 2012 in IET Communications
Orthogonal frequency division multiplexing (OFDM) technique has gained increasing popularity in both wired and wireless communication systems. However, in the conventional OFDM systems the insertion of a cyclic prefix (CP) and the transmission of periodic training sequences for purpose of channel estimation decrease the system's spectral efficiency. As an alternative to OFDM, isotropic orthogonal transform algorithm (IOTA)-based multicarrier system adopts a proper pulse shaping with good time and frequency localisation properties to avoid interference and maintain orthogonality in real field among sub-carriers without the use of CP. In this study, the authors propose linearly precoded IOTA-based multicarrier systems to achieve blind channel estimation by utilising the structure of auto-correlation and cross-correlation matrices introduced by precoding. The results show that the proposed IOTA-based multicarrier systems achieve better power and spectral efficiency compared with the conventional OFDM systems.