Jinsheng Jia

Jinsheng Jia

Auto-generated profile, based on publicly available information

Jinsheng Jia

State Key Laboratory of Green Building Materials, China Building Materials Academy, Beijing 100024, China

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 August 2022 in Materials
Verified
Journal Article
Open access
PDF file
WWWei Wang
Wei Wang
JJJinsheng Jia
Jinsheng Jia
YSYong Sun
Yong Sun
ZKZhuang Kong
Zhuang Kong
TNTianyi Na
Tianyi Na
QLQiang Li
Qiang Li
In this paper, an infiltration approach was proposed to generate a Ti3Si(Al)C2 transition layer in SiC matrix composites to effectually strengthen SiC ceramics. The infiltration temperature played a significant role in the evolution of the microstructure, phase composition, and flexural behaviours. Molten aluminium base alloy fully penetrated SiC ceramic after infiltration at different experimental temperatures (800–1000 °C). The phases in the reaction layer on the surface of SiC ceramic samples varied with the infiltration temperature. When infiltrated at 800 °C, only SiC and Al phases can be found in SiC composites, whereas at 900 °C, a reaction layer containing Ti3Si(Al)C2 and SiC was produced. The Ti3Si(Al)C2 phase grew in situ on SiC. At 1000 °C, the Ti3Si(Al)C2 phase was unstable and decomposed into TiC and Ti5Si3. The cermet phase Ti3Si(Al)C2 was synthesized at a relatively low temperature. Consequently, the flexural modulus and three-point bending strength of samples infiltrated at 900 °C was enhanced by 1.4 and 2.4 times for the original SiC ceramic, respectively.

17 December 2024
Verified
Book Chapter
Open access
PDF file
ZCZhenbo Cao
Zhenbo Cao
MZMeilun Zhang
Meilun Zhang
JJJinsheng Jia
Jinsheng Jia
Stripe is a kind of glass defect with complicated causes, which is difficult to avoid completely in production. Based on the serious influence of stripe defects on production efficiency in all-electric fused glass kiln, routine analyses were conducted to reveal its causes. According to the results, the kiln was adjusted but the problem remained unresolved. Finally, cracks at the bottom edge of the material basin were observed during the inspection of the structural elements. After the basin was replaced, the streaks disappeared, so it was determined that the defect at the bottom of the basin was the root cause of streaks. This paper can provide solutions for all-electric glass kiln and analysis of stripe defects in related industries, improve the solution efficiency and ensure the smooth operation of production.