In portable electronic devices, the output voltage of the Ni-MH cell battery gradually decreases with the extension of run time, eventually leading to an inability to provide the required operating voltage. As a result, this paper proposed a non-inverting buck-boost converter with automatic switching of operating modes to extend the run time of Ni-MH batteries connected in series, which is peak current controlled. By comparing the input and output voltages, the DC-DC converter is placed in either buck, boost, or buck-boost mode. Of the three modes, the buck-boost mode is designed to have the smallest operating range due to its lowest power conversion efficiency. The converter is characterised by a wide input range of 2.5–8 V, which exceeds the maximum voltage leading to oxide breakdown. In order to prevent the breakdown of the gate oxide layer, a capacitive coupling level shift circuit is proposed to control voltage between gate and source of the power transistor below 5 V. The proposed converter is manufactured using a 180 nm BCD process and occupies an effective chip area of 1.44 mm × 0.73 mm. Experimental results demonstrate that the maximum power conversion efficiency of the proposed buck-boost DC-DC converter is 93%, marking a significant 11% enhancement compared to the traditional buck-boost DC-DC converter operating in only buck-boost mode (84% efficient). In addition, the converter achieves a maximum output current of 500 mA, which improves the output maximum current by 67% compared to the traditional DC-DC converter (max. output current 300 mA).
Although the SiC MOSFETs with square or hexagonal designed cells have a small on-resistance, the electric fields of sharp corners within these designed cells lead to the reduction of blocking voltage. The SiC MOSFETs with linear cells can maintain the blocking voltage, while the relatively large cell usually increases the on-resistance and power consumption. In this article, we designed and fabricated the SiC MOSFETs with linear cells and interrupted linear cells whose N + region is embedded with the P + region. Then we compare their characteristics of specific on-resistance, forward characteristic, and blocking voltage, and report the demonstration of a high-voltage 4H-silicon carbide (SiC) MOSFETs with 20% losses of on-resistance by interrupting the N + region with P + region. We provide a new linear cell design that can effectively reduce the on-resistance of 1200 V SiC MOSFET and maintain the blocking voltage.