7 February 2023 in Optics Express
The full time-jitter response of a single-photon detector can make a significant contribution to the quantum bit error rate (QBER) of high repetition rate quantum key distribution (QKD) implementations. Although there have been studies into understanding the contribution for single-mode optical fiber coupled single-photon detectors, the contribution of larger, multimode core diameters to the QBER have not been explored in detail. With the growing importance of free-space QKD, which typically use multimode fibers to reduce coupling loss, it is vitally important to understand how the multimode fiber coupling will impact the total QBER. This work studies the impact of the time-jitter contribution to QBER when coupling a commercial off-the-shelf silicon single-photon avalanche diode with various multimode fibers while simulating operating at 1 GHz with empirical measurements taken at 1 MHz repetition rate. It was found that step-index multimode fibers can significantly increase the QBER, while graded-index fibers can provide an QBER contribution similar to a single-mode fiber. The results highlight that there is a significant benefit in using graded index multimode fibers for a free-space QKD receiver, particularly for high repetition rate applications.
26 February 2024 in IET Quantum Communication
In free‐space implementations of Quantum key distribution (QKD), the wide adoption of near‐Infrared wavelengths has led to the common use of silicon single‐photon avalanche diodes (Si‐SPAD) for receiver systems. While the impacts of some SPAD properties on QKD have been explored extensively, the relationship of spot‐size and spatial position on the full instrumental response and thus quantum bit error rate (QBER) has been studied little. Changes in spot size and spatial position can result from atmospheric turbulence and pointing and tracking errors. Here, An empirical analysis of that relationship is presented utilising a large active area, 500 μm, free‐space coupled Si‐SPAD designed for free‐space QKD. A baseline full‐width at half‐maximum timing jitter of 182 ps and a QBER contribution of 0.1 % for a 1 GHz clock frequency QKD system and 100 ps time‐gating window are reported. The impacts of spot‐size and spatial position can increase the QBER to over 0.3%. The link between the spot‐size and timing jitter will allow the understanding of tolerancing for the alignment of Si‐SPADs within free‐space QKD receiver systems—an important factor in designing properly engineered practical systems and the equipment needed to compensate for atmospheric turbulence and pointing and tracking.