1 January 2013 in International Journal of Hydrogen Energy
11 September 2011 in SAE International Journal of Advances and Current Practices in Mobility
In this study, the single-cylinder engine experiment was carried out to investigate the effect of multiple injections on stratified combustion characteristics in a spray-guided direct injection spark ignition engine. The engine was operated at 1200 rpm. The total injection quantity applied was 11 mg/stroke to represent a low-load condition. Single injection and multiple injection were tested. Split ratio of each multiple strategies were 1:1 for double injection and 1:1:1 for the triple injection respectively. Dwell time between each injection was set to 200 μs. In the result of engine experiment with the single injection, indicated mean effective pressure was increased as injection timing was retarded to top dead center due to the increased effective work. However, the retardation of the injection timing was limited by the misfire occurrence resulted from the locally rich mixture generation under the high ambient pressure. Moreover, at the injection timing where the maximum indicated mean effective pressure was shown, hydrocarbon and smoke emissions were increased due to the locally rich area of the stratified mixture. The multiple injection strategy was applied to enhance the local homogeneity of the stratified mixture. In the result of engine experiment with the double injection, indicated mean effective pressure and combustion efficiency were increased. As an index of combustion instability, coefficient variation of indicated mean effective pressure was decreased significantly with the double injection. This result implies that the local homogeneity of the stratified mixture was enhanced by the double injection. Hydrocarbon and carbon monoxide emissions were decreased significantly with the double also. Nitrogen oxides emissions were increased due to the increased in-cylinder temperature resulted by more activated combustion. With the triple injection, the flammable injection timing window became narrower. Furthermore, indicated mean effective pressure and combustion efficiency were decreased. This is likely because the stratified mixture was formed on the upper position of the spark plug due to then shortened spray penetration.
1 April 2021 in International Journal of Heat and Mass Transfer
13 September 2009 in SAE International Journal of Advances and Current Practices in Mobility
Two-stage injection strategy was studied in dimethyl-ether homogeneous charge compression ignition engine combustion. An early direct injection, main injection, was applied to form a premixed charge followed by the second injection after the start of heat release. Experiments were carried out in a single-cylinder direct-injection diesel engine equipped with a common-rail injection system, and the combustion performance and exhaust emissions were tested with the various second injection timings and quantities. Engine speed was 1200 rpm, and the load was fixed at 0.2 MPa IMEP. Main injection timing for homogeneous mixture was fixed at −80 CAD, and the fuel quantity was adjusted to the fixed load. Second injection quantity was varied from 1 to 5 mg, and the timing was selected according to the heat release rate of the HCCI combustion without second injection. From the results, two-stage injection strategy showed the possibility to overcome the disadvantages of HCCI such as high HC / CO emissions and difficult combustion phase control. Heat release rate and pressure rise rate were reduced with the second injection. The decreased premixed charge concentration by the second injection lowered the heat release from low temperature reaction and high temperature reaction. The second injection showed the separated heat release with the third peak in heat release rate curve as the fuel quantity exceeded 3 mg. This contributed to the power stroke enhancement, and fuel consumption reduction. Peak in-cylinder pressure was decreased as the second injection timing was retarded and the quantity was increased. The portion of the heat release after TDC was increased, and the pressure rise rate was reduced as the combustion phase was delayed and the burn duration was lengthened. However, the lowered bulk gas temperature with dropped in-cylinder pressure caused the CO emission level rise.