13 November 2018 in IEEE Communications Surveys & Tutorials
AVAthanasios V. Vasilakos
24 April 2017 in IEEE Transactions on Control of Network Systems
Many physical systems, such as water/electricity distribution networks, are monitored by battery-powered wireless-sensor networks (WSNs). Since battery replacement of sensor nodes is generally difficult, long-term monitoring can be only achieved if the operation of the WSN nodes contributes to long WSN lifetime. Two prominent techniques to long WSN lifetime are 1) optimal sensor activation and 2) efficient data gathering and forwarding based on compressive sensing. These techniques are feasible only if the activated sensor nodes establish a connected communication network (connectivity constraint), and satisfy a compressive sensing decoding constraint (cardinality constraint). These two constraints make the problem of maximizing network lifetime via sensor node activation and compressive sensing NP-hard. To overcome this difficulty, an alternative approach that iteratively solves energy balancing problems is proposed. However, understanding whether maximizing network lifetime and energy balancing problems are aligned objectives is a fundamental open issue. The analysis reveals that the two optimization problems give different solutions, but the difference between the lifetime achieved by the energy balancing approach and the maximum lifetime is small when the initial energy at sensor nodes is significantly larger than the energy consumed for a single transmission. The lifetime achieved by energy balancing is asymptotically optimal, and that the achievable network lifetime is at least 50% of the optimum. Analysis and numerical simulations quantify the efficiency of the proposed energy balancing approach.
21 February 2023 in Water Supply
This work proposes a reliable leakage detection methodology for water distribution networks (WDNs) using machine-learning strategies. Our solution aims at detecting leakage in WDNs using efficient machine-learning strategies. We analyze pressure measurements from pumps in district metered areas (DMAs) in Stockholm, Sweden, where we consider a residential DMA of the water distribution network. Our proposed methodology uses learning strategies from unsupervised learning (K-means and cluster validation techniques), and supervised learning (learning vector quantization algorithms). The learning strategies we propose have low complexity, and the numerical experiments show the potential of using machine-learning strategies in leakage detection for monitored WDNs. Specifically, our experiments show that the proposed learning strategies are able to obtain correct classification rates up to 93.98%.
27 September 2018 in IEEE Journal on Selected Areas in Communications
In a typical wirelessly powered sensor network (WPSN), wireless chargers provide energy to sensor nodes by using wireless energy transfer (WET). The chargers can greatly improve the lifetime of a WPSN using energy beamforming by a proper charging scheduling of energy beams. However, the supplied energy still may not meet the demand of the energy of the sensor nodes. This issue can be alleviated by deploying redundant sensor nodes, which not only increase the total harvested energy, but also decrease the energy consumption per node provided that an efficient scheduling of the sleep/awake of the nodes is performed. Such a problem of joint optimal sensor deployment, WET scheduling, and node activation is posed and investigated in this paper. The problem is an integer optimization that is challenging due to the binary decision variables and non-linear constraints. Based on the analysis of the necessary condition such that the WPSN be immortal, we decouple the original problem into a node deployment problem and a charging and activation scheduling problem. Then, we propose an algorithm and prove that it achieves the optimal solution under a mild condition. The simulation results show that the proposed algorithm reduces the needed nodes to deploy by approximately 16%, compared to a random-based approach. The simulation also shows if the battery buffers are large enough, the optimality condition will be easy to meet
3 February 2020 in IEEE Transactions on Wireless Communications
Wirelessly-powered sensor networks (WPSNs) are becoming increasingly important in different monitoring applications. We consider a WPSN where a multiple-antenna base station, which is dedicated for energy transmission, sends pilot signals to estimate the channel state information and consequently shapes the energy beams toward the sensor nodes. Given a fixed energy budget at the base station, in this paper, we investigate the novel problem of optimally allocating the power for the channel estimation and for the energy transmission. We formulate this non-convex optimization problem for general channel estimation and beamforming schemes that satisfy some qualification conditions. We provide a new solution approach and a performance analysis in terms of optimality and complexity. We also present a closed-form solution for the case where the channels are estimated based on a least square channel estimation and a maximum ratio transmit beamforming scheme. The analysis and simulations indicate a significant gain in terms of the network sensing rate, compared to the fixed power allocation, and the importance of improving the channel estimation efficiency.
7 June 2018 in IEEE Transactions on Wireless Communications
The lifetime of a wireless sensor network (WSN) determines how long the network can be used to monitor the area of interest. Hence, it is one of the most important performance metrics for WSN. The approaches used to prolong the lifetime can be briefly divided into two categories: reducing the energy consumption, such as designing an efficient routing, and providing extra energy, such as using wireless energy transfer (WET) to charge the nodes. Contrary to the previous line of work where only one of those two aspects is considered, we investigate these two together. In particular, we consider a scenario where dedicated wireless chargers transfer energy wirelessly to sensors. The overall goal is to maximize the minimum sampling rate of the nodes while keeping the energy consumption of each node smaller than the energy it receives. This is done by properly designing the routing of the sensors and the WET strategy of the chargers. Although such a joint routing and energy beamforming problem is non-convex, we show that it can be transformed into a semi-definite optimization problem (SDP). We then prove that the strong duality of the SDP problem holds, and hence the optimal solution of the SDP problem is attained. Accordingly, the optimal solution for the original problem is achieved by a simple transformation. We also propose a lowcomplexity approach based on pre-determined beamforming directions. Moreover, based on the alternating direction method of multipliers (ADMM), the distributed implementations of the proposed approaches are studied. The simulation results illustrate the significant performance improvement achieved by the proposed methods. In particular, the proposed energy beamforming scheme significantly out-performs the schemes where one does not use energy beamforming, or one does not use optimized routing. A thorough investigation of the effect of system parameters, including the number of antennas, the number of nodes, and the number of chargers, on the system performance is provided. The promising convergence behaviour of the proposed distributed approaches is illustrated.