30 November 2006 in IEEE Transactions on Industrial Electronics
AC machines supplied in parallel by a common voltage source inverter are sometimes used in industrial drives and railway traction applications. This reduction of power and control electronics leads to a reduction of cost, weight, and dimensions that is very useful for on-board systems. But this common supply imposes common voltages to all machines and the possibilities of independent behavior are reduced. In this paper, a graphical modeling is suggested to model such parallel drives for a railway application. A weighted control is then systematically deduced from this modeling and different possibilities of control are highlighted. Experimental results are provided to compare two of the deduced controls
8 August 2007 in IEEE Transactions on Industrial Electronics
FBFranÇois BonnetFrancois
The main idea developed in this paper is a novel biconverter structure to supply a doubly fed induction machine (DFIM). Two voltage source inverters (VSIs) feed the stator and rotor windings. The outputs of the two VSIs are combined electromechanically in the machine, and as a result, novel features can be obtained. For example, for high power drive applications, this configuration uses two inverters dimensioned for a half of the DFIM power. A new dual direct torque control is developed with flux model of DFIM. Two switching tables linked to VSI are defined for stator and rotor flux vector control. The satisfactory experimental and simulation results are shown, and they confirm good dynamic behavior in four quadrants of the speed-torque plane. Moreover, experimental results show the correct flux vector control behavior and speed tracking performances.
1 June 2012 in Microelectronics Reliability
19 September 2007 in Electrical Engineering
23 April 2018 in IEEE Transactions on Industry Applications
This paper illustrates the application of a solving method of linear systems to a multi-level inverter. This study applies a generic Pulse Width Modulation method to a multi-level topology. This method finally highlights some specific modulation schemes. Firstly, the study describes the mathematical model of the inverter leg. The leg is made of three level T-type structure. The model is extended to the three-phase inverter. The generalized inverse is used to generate the solution set of the conduction rates. Among the modulation strategies possible, three specific modulation schemes are proposed.The modulation schemes are applied to simulate a Pulse Width Modulation three-phase inverter. Finally, some experimental results complete the analysis.