In the present paper, effects of welding current, welding time, electrode pressure and holding time on the weld nugget size were studied. A failure mechanism was proposed to describe both interfacial and pullout failure modes. This mechanism was confirmed by SEM investigations. In the light of this mechanism, the effect of welding parameters on static weld strength and failure mode was studied. Then, an analytical model was proposed to predict failure mode and to estimate minimum nugget diameter (critical diameter) to ensure pullout failure mode in shear tensile test. On the contrary to existing industrial standards, in this model, critical nugget diameter is attributed to metallurgical characterisation of material (weld nugget hardness to failure location hardness ratio), in addition to sheet thickness. For a given sheet thickness, decreasing HWN/HFL increases interfacial failure mode tendency. The results of this model were compared with experimental data and also with the literature.
1 May 2008 in Materials Science and Engineering: A
The effects of weld nugget size and expulsion on the performance of low carbon steel resistance spot weld have been investigated in the present paper. Failure mode, peak load and failure energy obtained in tensile–shear test have been used to describe the performance of spot weld. The influence of voids and porosity as well as electrode indentation associated with expulsion on peak load and failure energy is discussed. The results showed that although expulsion does not reduce the load carrying capacity of spot welds, it decreases their energy absorption capability which was attributed to the change of failure location due to excessive electrode indentation associated with expulsion.
In this research, microstructure and overload failure behaviour of resistance spot welded DP980 were investigated. Microstructural characterisation, microhardness test and static tensile shear test were conducted. Fusion zone size proved to be the most important controlling factor of spot weld peak load and energy absorption. The results of this study demonstrated that the conventional weld size recommendation of d=4 t1/2 is not sufficient to ensure the pullout failure mode for DP980 steel resistance spot welds during the tensile shear test. In pullout mode, generally, failure was initiated at heat affected zone/base metal interface, where softening occurs due to the tempering of martensite. However, when heavy expulsion occurs, pullout failure tends to be initiated at fusion zone/heat affected zone interface. It was shown that heavy expulsion and associated large electrode indentation can reduce load carrying capacity and energy absorption capability of DP980 spot welds.