1 June 2021 in The Journal of the Acoustical Society of America
Additive manufacturing has expanded greatly in recent years with the promise of being able to create complex and custom structures at will. Enhanced control over the microstructure properties, such as percent porosity, is valuable to the acoustic design of materials. In this work, aluminum foams are fabricated using a modified powder bed fusion method, which enables voxel-by-voxel printing of structures ranging from fully dense to approximately 50% porosity. To understand the acoustic response, samples are measured in an acoustic impedance tube and characterized with the Johnson–Champoux–Allard–Lafarge model for rigid-frame foams. Bayesian statistical inversion of the model parameters is performed to assess the applicability of commonly employed measurement and modeling methods for traditional foams to the additively manufactured, low porosity aluminum foams. This preliminary characterization provides insights into how emerging voxel-by-voxel additive manufacturing approaches could be used to fabricate acoustic metal foams and what could be learned about the microstructure using traditional measurement and analysis techniques.
1 August 2023 in The Journal of the Acoustical Society of America
Acoustic communications often have limited data rates because of the intrinsically low frequencies. Exploring new spatial modes to increase data bandwidth at fixed frequency is a possible solution to this problem. Here, we demonstrate acoustic wave chirality transmission between two reciprocal metamaterial vortex wave antennas, generating and sensing transmitted acoustic wave chirality through the sub-wavelength geometry of the system. By adding an acoustic leaky wave surface to a ring resonator waveguide, acoustic vortex waves with positive or negative integer mode chirality are independently radiated and detected using a small number of microphones. Through computational simulation and experimental verification, using three-dimensional printed waveguides, we show that the vortex mode chirality can be transferred between two opposing acoustic vortex wave antennas across a small unguided air gap. We also show that emission into an external waveguide can provide long distance data transmission. This demonstrates the first use of metamaterial vortex wave antennas as chiral, mode multi-channel data transceivers.
1 October 2026 in The Journal of the Acoustical Society of America
The rapid growth of research in advanced acoustic materials has been enabled by contemporary growth in additive manufacturing advancement and accessibility. This report provides a quantitative evaluation of variability in the elastic vibration response of structures fabricated using fused deposition modeling. The approach in this study involves assembling a sample set from six institutions via an interlaboratory round robin study. Slender beam samples were fabricated using fused deposition modeling and a standardized commercial filament and printed on whichever commercial printers were available at each institution. To quantify variability in fabrication of both bulk material and metamaterial-inspired features, two sample sets were requested and tested, a set of plain beams and a set of beams with embedded resonator. All samples were measured for dimensional accuracy and dynamic performance using a vibration shaker using a laser Doppler vibrometer. Measured resonance response of each set of samples revealed that the variability between printers was roughly 20% in bulk dynamic properties and as large as 280% in coupled resonator-beam dynamic performance. The study provides design bounds for metamaterial design across various printer hardware and highlights the importance of understanding repeatability using this fabrication approach.