Shanghai Key Laboratory of Special Artificial Microstructure Materials and Technology School of Physics Science and Engineering Tongji University Shanghai 200092 P. R. China
Auto-generated profile, based on publicly available information
Hongqiang Wang
Shanghai Key Laboratory of Special Artificial Microstructure Materials and Technology School of Physics Science and Engineering Tongji University Shanghai 200092 P. R. China
Resveratrol is a natural active ingredient found in plants, which is a polyphenolic compound and has a variety of pharmaceutical uses. Resveratrol-loaded TEMPO-oxidized cellulose aerogel (RLTA) was prepared using a freeze-drying method, employing high speed homogenization followed by rapid freezing with liquid nitrogen. RLTAs were designed at varying drug–cellulose aerogel ratios (1:2, 2:3, 3:2, and 2:1). It could be seen via scanning electron microscopy (SEM) that Res integrated into TEMPO-oxidized cellulose (TC) at different ratios, which changed its aggregation state and turned it into a short rod-like structure. Fourier transform infrared (FTIR) spectra confirmed that the RLTAs had the characteristic peaks of TC and Res. In addition, X-ray diffraction (XRD) demonstrated that the grain size of RLTA was obviously smaller than that of pure Res. RLTAs also had excellent stability in both simulated gastric fluid and phosphate buffer solution. The drug release rate was initially completed within 5 h under a loading rate of 30.7 wt%. The results of an MTT assay showed the low toxicity and good biocompatibility of the RLTAs. TC aerogel could be a promising drug carrier that may be widely used in designing and preparing novel biomedicine.
Capacitive deionization (CDI) technology possessing excellent desalination performance and energy efficiency is currently being widely studied in seawater desalination. In this work, the graphene–composite carbon aerogels (GCCAs) easily prepared by an ambient pressure drying method served as electrodes to remove salt ions in aqueous solution by CDI. The microstructure of the obtained GCCAs was found to depend on the component content in the precursor solution, and could be controlled through varying the mass ratio of resorcinol and formaldehyde to graphene oxide (RF/GO). The surface characteristics and microstructure of GCCAs were characterized by Raman spectroscopy, X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM). In addition, the electrochemical tests and CDI experiments of GCCA electrodes were conducted in NaCl solution. Thanks to the reasonable pore structure and highly conductive network, GCCA-150 achieved the best salt adsorption capacity of 26.9 mg/g and 18.9 mg/g in NaCl solutions with concentrations of 500 mg/L and 250 mg/L, respectively.