1 April 1991 in Physical Review Letters
We describe a novel magnetotunneling spectroscopy technique for probing the complicated dispersion curves of hole states in the quantum well of p-type double-barrier resonant-tunneling structures. Strong mixing between light- and heavy-hole states is observed. Some of the states clearly exhibit a negative hole effective mass for motion in the plane of the quantum well.
24 October 2003 in The Journal of Chemical Physics
Good quality thin films of poly(2,5-bis(2′-ethyl-hexyl)–1,4-phenylenevinylene) (BEH–PPV) were optically characterized by photoluminescence, absorption, and Raman scattering techniques. The temperature evolution of the vibronic structures in the photoluminescence and absorption spectra was analyzed. At low temperatures it was possible to identify the different phonon modes that contribute to the vibronic spectra. The correlation of the Raman and photoluminescence spectra enabled us to conclude that the main vibrational modes are the two most intense Raman bands at 1310 and 1579 cm−1. The emission efficiency highly increases and the absorption spectra become much more resolved with decreasing temperature. The temperature dependence of the zero-phonon line in the absorption and photoluminescence measurements is attributed to an increase of the effective conjugation length at low temperatures. The results from the polarization-resolved photoluminescence demonstrated the high degree of the in-plane structural order in the BEH–PPV films, corroborating to the relatively high conjugation length obtained from the analysis of the Huang–Rhys factor.
1 November 2007 in Dental Materials
VPVanessa Maria F. Paulinelli
Vanessa Maria F. Paulinelli
16 April 2010 in Chemical Physics Letters
4 March 2008 in The Journal of Chemical Physics
The temperature dependence of the photoluminescence properties of a thin film of poly[2-methoxy-5-(2′-ethylhexyloxy)-p-phenylene-vinylene], MEH-PPV, fabricated by spin coating, is analyzed. The evolution with temperature of the peak energy of the purely electronic transition, of the first vibronic band, of the effective conjugation length, and of the Huang–Rhys factors are discussed. The asymmetric character of the pure electronic transition peak and the contribution of the individual vibrational modes to the first vibronic band line shape are considered by a model developed by Cury et al. [J. Chem. Phys. 121, 3836 (2004)]. The temperature dependence of the Huang–Rhys factors of the main vibrational modes pertaining to the first vibronic band allows us to identify two competing vibrational modes. These results show that the electron coupling to different vibrational modes depends on temperature via reduction of thermal disorder.
1 August 1990 in Journal of the Optical Society of America B
We measured the intensity pattern of an Ar-laser beam after its passage through GdAlO3:Cr+3 and Al2O3:Cr+3 (ruby) crystals. We observed distortions and the formation of spatial rings; we interpret the results as evidence of transverse self-phase modulation, as previously observed in a thermal nonlinear medium [ Appl. Phys. Lett. 6, 362 ( 1970)] and in nonlinear thin films [ Opt. Lett. 9, 411 ( 1984)]. We measured the transient behavior of the pattern in order to investigate the temporal response of the nonlinearity. Theoretical calculations were made by using the Kirchhoff diffraction integral, where we considered the following parameters: the nonlinear index of refraction n2 {which was previously measured by Catunda et al. [ Appl. Opt. 25, 2391 ( 1986)]}, the saturation intensity Is, and the response time τ. We show that the dispersive character of the nonlinearity and its saturation behavior [n2 ∝ (1 + I/Is)−1] are important in determining the intensity pattern. Good agreement between the experimental and calculated results was verified.