Abdel Halim Zitouni

Abdel Halim Zitouni

Auto-generated profile, based on publicly available information

Abdel Halim Zitouni

Research Center in Industrial Technologies , CRTI P. O. Box 64, Cheraga, Algiers 16014 , Algeria

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 May 2020 in Experimental and Computational Multiphase Flow
Verified
Journal Article
Open access
PDF file
AZA. H. Zitouni
A. H. Zitouni
Abderraouf ArabiAbderraouf Arabi
Abderraouf Arabi
Yacine SALHIYacine SALHI
Yacine SALHI
YZYoucef ZENATI
Youcef ZENATI
EAEL KHIDER SI AHMED
EL KHIDER SI AHMED
Jack LegrandJack Legrand
Jack Legrand
The purpose of this work is to analyze the influence of a sudden expansion on the upstream behavior of the horizontal gas-liquid slug flow. Measurements were made on a 40 mm ID pipe with and without a sudden enlargement of aspect ratio σ = 0.444. The experiments were carried out with two-phase air-water mixture. The slug lengths and frequencies were measured using a non-intrusive video technique. Upstream the sudden enlargement, it was observed that the mixture velocity has no influence on slug length. The variation of slug frequency is found proportional to the liquid superficial velocity for the two cases within this study. It was also observed that the behavior of the slug length and frequency was affected by the presence of the sudden enlargement. The comparison of the results obtained with various empirical correlations available in the literature showed that the latter are not worthwhile in the case where singularity is installed.

31 October 2023 in Journal of Solar Energy Engineering
Verified
Journal Article
Closed access
PDF file
MDMohamed Salim Djenane
Mohamed Salim Djenane
SHSeddik Hadji
Seddik Hadji
OTOmar Touhami
Omar Touhami
AZAbdel Halim Zitouni
Abdel Halim Zitouni
This paper proposes an investigation of a novel design of receiver absorber tube (circular–trapezoidal shaped) for parabolic trough concentrator (PTC) system aiming at catching a part of the lost (reflected) solar rays due to effects related to the incidence angle deviation and thus improving the PTC's thermal performance. Although they are always present in PTC, the effects of the deviation angle are often not considered in the literature. These effects are considered here in view of presenting a better and more useful focal area, the optimal circular–trapezoidal absorber tube shape is determined according to the maximal limit of the deviation angle that allows catching the maximum amount of solar rays. The corresponding model is established considering it as a two-dimensional problem and the derived deviation angle coefficient is compared to that obtained for a traditional circular-shaped tube. Moreover, the energy balance model is adapted to simulate the thermal efficiency of the considered tubes as a function of the deviation angle with some assumptions. The obtained results prove that from a deviation angle value of 0.1 deg, the gain in efficiency becomes more significant; it can reach 5% and even be higher for a deviation angle value of 0.5 deg. Finally, comsol multiphysics software package was used to determine the pressure drops, temperature, and velocity field distributions, considering a deviation angle value of 0.2 deg. The results confirm that the proposed tube absorbs more heat than the traditional one.

24 January 2020 in International Journal on Interactive Design and Manufacturing (IJIDeM)
Verified
Journal Article
Closed access
PDF file
AZAbdel Halim Zitouni
Abdel Halim Zitouni
PSPierre Spiteri
Pierre Spiteri
MAMouloud Aissani
Mouloud Aissani
YBYounes Benkheda
Younes Benkheda