Naveen Guruprasad

Naveen Guruprasad

Auto-generated profile, based on publicly available information

Naveen Guruprasad

Department of Chemical Engineering and Chemistry, Sustainable Process Engineering Group, Eindhoven University of Technology, Eindhoven, 5600 MB, The Netherlands

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 June 2024 in Journal of Power Sources
Verified
Journal Article
Open access
NGNaveen Guruprasad
Naveen Guruprasad
JSJohn Van der Schaaf
John Van der Schaaf
MGMatheus T. de Groot
Matheus T. de Groot

11 February 2026 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
NGNaveen Guruprasad
Naveen Guruprasad
JSJohn Van der Schaaf
John Van der Schaaf
MGMatheus T. de Groot
Matheus T. de Groot
Enhancing catalyst-layer efficiency and durability at high current densities is essential for scalable electrolyzer deployment. Unlike proton exchange membrane systems that are dominated by anodic losses, anion exchange membrane (AEM) systems can exhibit catalyst layer resistances at both electrodes, warranting the use of reference electrodes for kinetic decoupling. We present a methodology to quantify catalyst layer resistance, utilization heterogeneity, and transport limitations (ionic or electronic) by means of impedance diagnostics with dual reference electrodes integrated in the flow channels of each half-cell. Under nominal catalyst loading, we observed elevated local current densities near the membrane anode catalyst interface, implicating ionic conductivity as the primary cause. For the cathode, electronic resistance seems to be limiting. Combined, they manifest as an additional 50–80 mV overpotential attributable to the catalyst layer, a non-negligible fraction of the total 1.9 V of cell voltage at 2 A cm −2 . Reducing the catalyst loading improved the reaction homogeneity at the anode; however, for the cathode, it resulted in a marked decrease in effective electronic conductivity, which exacerbated the spatial heterogeneity and further elevated the cathodic kinetic overpotential. These findings highlight the need for designing and evaluating catalyst layer morphologies for balanced electrochemical activity and efficiency.

11 November 2026 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
NGNaveen Guruprasad
Naveen Guruprasad
JSJohn Van der Schaaf
John Van der Schaaf
MGMatheus T. de Groot
Matheus T. de Groot
Hydrogen gas crossover limits part-load flexibility and pressurized operation of anion exchange membrane water electrolysis. This phenomenon is often attributed to the membrane properties, while the influence of cell architecture remains poorly quantified. In this work, two zero-gap cells (a commercial Baltic flow cell and a 3D printed diagnostic cell) with identical membrane electrode assembly (MEA) were tested in 1 M KOH at 25 °C and 60 °C to isolate the effect of cell topology. A 1D transport model was further developed to isolate the contributions of membrane and dissolved hydrogen supersaturation at the catalyst layer to the measured crossover flux. The two cells showed a 2.9 fold difference in crossover, which was attributed to differences in catalyst-layer supersaturation. Comparison with independently reported data for the same commercial platform operated with a hydrophobic carbon gas diffusion electrode at the cathode, shows a further reduction of crossover by more than an order of magnitude. Across the published PEM and alkaline studies the catalyst-layer supersaturation varies by at least two orders of magnitude. A Pt/C recombination layer reduced crossover by 40%, but with the voltage penalty of 230 mV. Cathode redesign can therefore substantially reduce crossover using existing membranes, without adding any significant efficiency penalty.