15 May 2020 in Smart Materials and Structures
Piezoelectric energy harvesters tend to convert energy from ambient vibration to electricity, which can gain a higher output voltage at resonance region. How to obtain a larger working bandwidth is urgent to explore at present. In this paper, a cantilever plate energy harvester is designed, with two boxes added at two free edges along the fixed-free direction and one rolling ball placed in each boxes respectively. The natural frequency of the structure can be adjusted by changing the centroid of the structure, which is caused by the balls rolling in the box. The range of adjustment that contains from the maximum (upper limit) to minimum (lower limit) frequency, is defined as the theoretical frequency band. The mode function of tunable cantilever plate is given according to deflection curve. Considering the rigid body motion of boxes and the composite motion of the balls, the Hamilton principle and the Hertz contact theory are taken into account to derive the vibration equations of the system. The experiment is carried out to verify the correctness of the theoretical mode and the dynamic equations. The responses of the structure under different excitation frequencies are calculated by using MATLAB software and verified by frequency sweep experiment. The results show that the working bandwidth of proposed structure under different balls initial positions is wider than with that of beam structure in resonance, thus proving the better tuning ability of the designed system. In addition, the output of the energy harvester under different external excitation acceleration is given. The effects of different length of box on the working bandwidth and output power density are studied. The relationship between conversion rate and external resistance is proposed under different boxes length. A high performance energy harvester with wider operating frequency range is designed.
1 February 2020 in Applied Mathematical Modelling
9 March 2019 in Applied Physics A
16 December 2018 in Journal of Nanomaterials
A microbistable piezoelectric energy harvester has been developed. The harvester was based on a center-fixed and quadrilateral-free microbistable plate with mass blocks placed at the four corners. Considering the thermoelectromechanical coupling effect, a nonlinear oscillation differential equation was established by Hamilton’s principle. Strain gradient theory was applied to consider the size effect, and von Karman theory was used to consider the large deformation effect. The influences of the laying position and area of the piezoelectric layer on the efficiency of energy capture were investigated. The voltage-frequency response of the nonlinear system was investigated, and the snap-through behavior of the bistable plate results in energy harvesting achieving the ideal broaden frequency range before the resonance region.
1 January 2005 in International Journal of Nonlinear Sciences and Numerical Simulation
3 April 2018 in SAE International Journal of Advances and Current Practices in Mobility
Boost converter is widely applied to hybrid electric vehicles (HEV). Typical control methods employ two proportional-integral (PI) regulators to fulfill DC bus voltage closed-loop control and inductor current closed-loop control, respectively. They have intrinsic performance limitations: 1) slow dynamic response of DC bus voltage regulation; 2) high overshoot voltage during transient state; 3) it is difficult to design four gains best fit all operational conditions. This paper proposes a model prediction based boost converter control method for HEV applications. The proposed control method employs model based instantaneous power prediction and dynamic optimization in real time by minimizing a defined cost function to overcome above issues. First of all, the issues of typical control methods are analyzed. Then, the proposed control method is presented in detail, followed by simulation verification and comparison with PI based control method. Simulation results show that the proposed control method provides much better performance to boost converter system than the PI-based control.