Yu. S. Haiduk

Yu. S. Haiduk

Auto-generated profile, based on publicly available information

Yu. S. Haiduk

Belarussian State University, Minsk, Belarus

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 May 2023 in Scientific Reports
Verified
Journal Article
Open access
PDF file
AKAlexander Khort
Alexander Khort
YHYulyan Haiduk
Yulyan Haiduk
ITIgor Taratyn
Igor Taratyn
DMDmitry Moskovskikh
Dmitry Moskovskikh
KPKirill Podbolotov
Kirill Podbolotov
VPVladimir Pankov
Vladimir Pankov
The control of atmosphere content and concentration of specific gases are important tasks in many industrial processes, agriculture, environmental and medical applications. Thus there is a high demand to develop new advanced materials with enhanced gas sensing characteristics including high gas selectivity. Herein we report the result of a study on the synthesis, characterization, and investigation of gas sensing properties of In2O3–graphene–Cu composite nanomaterials for sensing elements of single-electrode semiconductor gas sensors. The nanocomposite has a closely interconnected and highly defective structure, which is characterized by high sensitivity to various oxidizing and reducing gases and selectivity to NO2. The In2O3-based materials were obtained by sol–gel method, by adding 0–6 wt% of pre-synthesized graphene–Cu powder into In-containing gel before xerogel formation. The graphene–Cu flakes played the role of centers for In2O3 nucleation and then crystal growth terminators. This led to the formation of structural defects, influencing the surface energy state and concentration of free electrons. The concentration of defects increases with the increase of graphene–Cu content from 1 to 4 wt%, which also affects the gas-sensing properties of the nanocomposites. The sensors show a high sensing response to both oxidizing (NO2) and reducing (acetone, ethanol, methane) gases at an optimal working heating current of 91–161 mA (280–510 °C). The sensor with nanocomposite with 4 wt% of graphene–Cu additive showed the highest sensitivity to NO2 (46 ppm) in comparison with other tested gases with an absolute value of sensing response of (− ) 225 mV at a heating current of 131 mA (430 °C) and linear dependence of sensing response to NO2 concentration.

1 January 2023 in Russian Journal of Inorganic Chemistry
Verified
Journal Article
Closed access
PDF file
YHYu. S. Haiduk
Yu. S. Haiduk
AUA. E. Usenka
A. E. Usenka
LRL. S. Rutkovskaya
L. S. Rutkovskaya
RGR. P. Golodok
R. P. Golodok
ATA. S. Timonenkova
A. S. Timonenkova
VPV. V. Pankov
V. V. Pankov
Indium oxide–graphene composites (containing 0–6.0 wt % graphene) were manufactured by the sol–gel process. The phase composition, microstructure, and gas-sensitive properties of the prepared materials were studied. The composites consist of isolated In2O3 and graphene phases, where graphene is predominantly adsorbed on the surfaces of indium oxide grains (the indium oxide grain sizes are 8–11 nm). The nanocomposites are distinguished by an enhanced sensitivity to both reducing gases (CH4, acetone) and oxidative gases (NO2). A far greater enhancement is in the sensory response to oxidative gases. Presumably, the major factors influencing the sensory properties of the composite are the high defectiveness of In2O3 and graphene phases, higher specific surface areas of composites compared to those of individual In2O3, and the likely formation of p–n junctions in the indium oxide and graphene contact zone. Graphene additives to indium oxide can improve the main performances (sensory response, response time, and recovery time) of single-electrode semiconductor sensors.

1 May 2024 in Inorganic Materials
Verified
Journal Article
Closed access
PDF file
YHYu. S. Haiduk
Yu. S. Haiduk
ITI. A. Taratyn
I. A. Taratyn
AUA. E. Usenka
A. E. Usenka
DID. V. Ivashenko
D. V. Ivashenko
VPV. V. Pankov
V. V. Pankov
Indium oxide–graphene (In2O3/Gr) composites (2.0 and 4.0 wt % graphene) have been prepared by sol–gel synthesis and the microstructure and gas-sensing properties of the composites (in the composition of single-electrode ceramic sensors) have been studied. The composites have the form of heterogeneous systems formed by the In2O3 phase ranging in crystallite size from 7 to 12 nm and the graphene phase. The microstructure of the composites has been shown to depend on the fabrication process. The In2O3/Gr-based sensors have higher sensitivity to reducing (CH4) and oxidizing (NO2) gases than do In2O3-based sensors and shorter response and recovery times. Possible causes of their better gas sensitivity are the formation of spatially separated positively and negatively charged regions, which leads to electron concentration redistribution in individual phases; the increased defect density in the indium oxide and graphene phases in the composite; and the large specific surface area of graphene.

1 January 2023 in Žurnal neorganičeskoj himii
Verified
Journal Article
Closed access
PDF file
YHYu. S. Haiduk
Yu. S. Haiduk
AUA. E. Usenka
A. E. Usenka
LRL. S. Rutkovskaya
L. S. Rutkovskaya
RGR. P. Golodok
R. P. Golodok
ATA. S. Timonenkova
A. S. Timonenkova
ГСГайдук Ю. С.
Гайдук Ю. С.
Композиция оксида индия с графеном, полученная золь-гель методом, и одноэлектродные газовые сенсоры на ее основе