24 June 1991 in Applied Physics Letters
Measurements of the contact potential difference between different materials have been performed for the first time using scanning force microscopy. The instrument has a high resolution for both the contact potential difference (better than 0.1 mV) and the lateral dimension (<50 nm) and allows the simultaneous imaging of topography and contact potential difference. Images of gold, platinum, and palladium surfaces, taken in air, show a large contrast in the contact potential difference and demonstrate the basic concept.
15 May 1987 in Journal of Applied Physics
A modified version of the atomic force microscope is introduced that enables a precise measurement of the force between a tip and a sample over a tip-sample distance range of 30–150 Å. As an application, the force signal is used to maintain the tip-sample spacing constant, so that profiling can be achieved with a spatial resolution of 50 Å. A second scheme allows the simultaneous measurement of force and surface profile; this scheme has been used to obtain material-dependent information from surfaces of electronic materials.
18 May 1987 in Applied Physics Letters
We describe a new method for imaging magnetic fields with 1000 Å resolution. The technique is based on using a force microscope to measure the magnetic force between a magnetized tip and the scanned surface. The method shows promise for the high-resolution mapping of both static and dynamic magnetic fields.
28 March 1988 in Applied Physics Letters
We demonstrate the usefulness and high sensitivity of the atomic force microscope (AFM) for imaging surface dielectric properties and for potentiometry through the detection of electrostatic forces. Electric forces as small as 10−10 N have been measured, corresponding to a capacitance of 10−19 farad. The sensitivity of our AFM should ultimately allow us to detect capacitances as low as 8×10−22 F. The method enables us to detect the presence of dielectric material over Si, and to measure the voltage in a p‐n junction with submicron spatial resolution.
25 August 1995 in Science
Interferometric near-field optical microscopy achieving a resolution of 10 angstroms is demonstrated. The scattered electric field variation caused by a vibrating probe tip in close proximity to a sample surface is measured by encoding it as a modulation in the optical phase of one arm of an interferometer. Unlike in regular near-field optical microscopes, where the contrast results from a weak source (or aperture) dipole interacting with the polarizability of the sample, the present form of imaging relies on a fundamentally different contrast mechanism: sensing the dipole-dipole coupling of two externally driven dipoles (the tip and sample dipoles) as their spacing is modulated.
26 September 1994 in Applied Physics Letters
We demonstrate a new method whereby near-field optical microscope resolution can be extended to the nanometer regime. The technique is based on measuring the modulation of the scattered electric field from the end of a sharp silicon tip as it is stabilized and scanned in close proximity to a sample surface. Our initial results demonstrate resolution in the 3 nm range—comparable to what can be achieved with typical attractive mode atomic force microscopes. Theoretical considerations predict that the ultimate resolution achievable with this approach could be close to the atomic level.