Hydrogen-rich materials infused in nanoscaffolds offer a promising approach to on-board hydrogen storage. A mesoporous scaffold decreases the temperature for hydrogen release from ammonia borane (AB), a conventional hydrogen-storage material, to below 80 °C and leads to an increase in the purity of the hydrogen released. (See schematic representation of a hydrogen-bonded AB network in the cross-section of a single pore.) <!--EMPTY SOURCE-->
We present theoretical and experimental results regarding the thermodynamic stability of the high-k dielectrics and in contact with Si and The interface is found to be stable with respect to formation of silicides whereas the interface is not. The interface is marginally unstable with respect to formation of silicates. Cross-sectional transmission electron micrographs expose formation of nodules, identified as silicides, across the polycrystalline interfaces but not for the interfaces with For both and the x-ray photoemission spectra illustrate formation of silicate-like compounds in the interface.
1 July 2004 in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
We address the issue of accurate determination of the valence band maximum (VBM) for SrTiO3(001) single crystals and epitaxial films, as well as TiO2(001) anatase and SrO epitaxial films. These measurements are of critical importance in determining valence band offsets in heterojunctions of these oxides with Si. Three different methods are analyzed: (1) fitting a Gaussian broadened theoretical density of states to the x-ray photoelectron valence band spectrum; (2) finding the intersection of a regression line that spans the linear portion of the x-ray photoelectron valence band leading edge with the background between the valence band maximum and the Fermi level; and (3) determining the energy at which high-resolution ultraviolet photoemission intensity at the leading edge goes to zero. We find that method 1 yields physically unreasonable results when used in conjunction with density functional theory because the latter does not predict the detailed shape of the valence bands in these oxides with sufficient accuracy. In contrast, methods 2 and 3 give physically reasonable results that are in good mutual agreement. The difference in VBM between method 1 and methods 2 and 3 is 0.4–0.6 eV, depending on the oxide. Methods 2 and 3 yield the most reliable VBM, provided the experiments are carried out with adequate energy resolution.
The total energy and equation of state of the monoclinic, tetragonal, cubic, orthorhombic-I (Pbca) and orthorhombic-II (cotunnite) phases of zirconia and hafnia are determined using density functional theory (DFT) in the local density (LDA) and generalized-gradient (GGA) approximations. It is found that GGA corrections are needed to obtain low-temperature phase transitions under pressure that are consistent with experiment, i.e., . The GGA values of the bulk modulus of the cotunnite phase are found to be 251 and for and respectively, highlighting the similarity of these two compounds. We introduce a population analysis scheme in which atomic radii are adapted to the actual charge distribution in the material. The results indicate that the effective atomic radius of Hf is smaller than that of Zr, a drastic manifestation of the relativistic lanthanide contraction. The population analysis demonstrates that ionicity: (i) decreases from the monoclinic to the cotunnite phase, and (ii) is larger for than for . The bandgap and heat of formation are also larger for monoclinic than for by and / formula unit, respectively. The tetragonal phase, which often exists as a metastable phase at ambient conditions, has a bandgap larger than the monoclinic phase by 0.35 and for and , respectively.