A highly efficient solid‐base organocatalyst for the gas‐phase aldol self‐condensation of n‐butanal to 2‐ethylhexenal was developed by grafting site‐isolated amines on tailored silica surfaces. The catalytic activity depends largely on the nature of amine species, the surface concentration of amine and silanol groups, and the spatial separation between the silanol and amine groups. In situ FTIR measurements demonstrated that the formation of nucleophilic enamines leads to the enhanced catalytic activity of secondary amine catalysts, whereas the formation of imines (stable up to 473 K) leads to the low activity observed for silica‐supported primary amines. Blocking the silanol groups on the silica support by silylation or cofeeding water into the reaction stream drastically decreased the reaction rates, demonstrating that weaker acidic silanol groups participate cooperatively with the amine groups to catalyze the condensation reaction. This work demonstrates that the spatial separation of the weakly acidic silanols and amines can be tuned by the controlled dehydration of the supporting silica and by varying the linker length of the amine organosilane precursor used to graft the amine to the support surface. A mechanism for aldol condensation was proposed and then analyzed by DFT calculations. DFT analysis of the reaction pathway suggested that the rate‐limiting step in aldol condensation is carboncarbon bond formation, which is consistent with the observed kinetics. The calculated apparent activation barrier agrees reasonably with that measured experimentally.
We report on a new route to produce hexane-1,2,5,6-tetrol (tetrol) from cellulose-derived levoglucosanol (lgol). We investigate the reaction intermediates formed over metal and acid catalysts, and propose a reaction network for this process. Lgol is converted to tetrol in up to 90% yield over a bifunctional Pt/SiO2–Al2O3 catalyst at 150 °C. High tetrol yields are maintained at lgol concentrations of up to 21 wt% in water. threo- and erythro-lgol first undergo hydrolysis to 3,4-dideoxymannose (DDM) and 3,4-dideoxyglucose (DDG), respectively. This reaction can be carried out selectively over an Amberlyst 70 acid catalyst at a temperature of 100 °C. At a higher temperature of 150 °C with no added catalyst, DDM and DDG undergo aldose–ketose isomerization to 3,4-dideoxyfructose (DDF). DDM is hydrogenated to cis-tetrol over a Pt/SiO2 catalyst, while DDG is hydrogenated to trans-tetrol. Formation of DDF erases the stereocenter at the C2 position of lgol, and hydrogenation of DDF produces a nearly 1 : 1 mixture of cis- and trans-tetrol. This catalytic approach to produce tetrol from biomass opens the door to sustainable chemicals derived from tetrol.