Hyun Chul Kang

Hyun Chul Kang

Auto-generated profile, based on publicly available information

Hyun Chul Kang


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2024 in International Journal of Energy Research
Verified
Journal Article
Open access
JYJinUk Yoo
JinUk Yoo
DKDong Chul Kang
Dong Chul Kang
HKHyun Chul Kang
Hyun Chul Kang
Songhun YoonSonghun Yoon
Songhun Yoon
SPSung Gyu Pyo
Sung Gyu Pyo
The cathode of a lithium‐ion battery (LIB) is made from a slurry of cathode active materials, conductive additives, and binder mixtures, which is blade‐coated to fabricate the cathode electrode. The blade coating is a wet coating technology, which requires a heat treatment process after casting to volatilize the solvent. In addition, due to the dense surface, the reaction occurs mainly on the surface during the charge and discharge cycle, which accelerates degradation. To address these problems, this study introduces electrospun coatings during slurry casting. Electrospinning (ES) is a fast, easy, and low‐cost process that is not limited by external conditions and is typically used to produce nanofibers. However, if the polymer solution concentration is extremely low, a porous film can be formed by electrospraying. Porous films tend to degrade more slowly because the reaction occurs across the entire electrode. In addition, ES does not require a drying process as the solvent is volatilized during the process. While the blade coating shows 47.13% retention after 100 cycles at 1C, ES shows an improved retention of 75.98%. The application of ES to LIB results in a significant improvement in cycle performance, which can be developed into a breakthrough technology in electrode fabrication.

1 January 2025 in International Journal of Energy Research
Verified
Journal Article
Open access
JYJinUk Yoo
JinUk Yoo
DKDong Chul Kang
Dong Chul Kang
HKHyun Chul Kang
Hyun Chul Kang
Songhun YoonSonghun Yoon
Songhun Yoon
SPSung Gyu Pyo
Sung Gyu Pyo
Electrospray, introduced to the coating process, enables the fabrication of porous electrodes, and electrosprayed cathodes exhibit improved cycle performance. Further, the solvent used in the cathode slurry of the electrospray coating plays a crucial role. This study investigated the effects of various solvents on the electrospray of Ni‐rich layered materials for electrode fabrication as an alternative to conventional slurry coating using the doctor‐blade method. The electrode performance of a typical doctor blade method using the N‐methyl‐2‐pyrrolidone (NMP) solvent, which has various disadvantages (boiling and autoignition temperature), was compared with that of electrosprayed cathodes using NMP; N,N‐dimethylformamide (DMF); and DMF/acetone solvents. The volatility difference between the three solvents resulted in the creation of individual cathodes with different porosities. For the DMF/acetone solvent, which had the highest volatility, the coated cathode showed 75.97% capacity retention after 100 cycles at 1C, which was significantly higher than those of the NMP (62.91%) and DMF (66.25%) solvents. Electrochemical impedance spectroscopy (EIS) showed a stable peak retention during cycling and a low increase in individual resistance for the DMF/acetone solvent cathode. To conclude, optimizing solvent selection in electrosprayed cathodes is highly critical for enhancing the cathode cycling performance, contributing to high‐performance lithium‐ion batteries.