1 March 2020 in Physics of Fluids
A synthetic jet actuator is a fluidic device that produces a jet flow by the periodic ingestion of fluid into and expulsion of fluid out of a cavity across an orifice. Since such a mechanism transfers linear momentum to the fluid without introducing a net mass into the system over an actuation cycle, the synthesized jet is also termed a zero-net-mass-flux jet. Over the last two decades, synthetic jets have been the subject of intense research. It has been shown that the geometric parameters of a synthetic jet actuator can strongly influence the flow characteristics and performance of synthetic jets. The aim of this paper is to provide a comprehensive review of the influence of the geometric parameters of a synthetic jet actuator on the characteristics and performance of synthetic jets. These parameters include the height and diameter of the cavity and the orifice and the shape and edge configuration of the orifice.
1 January 2019 in Journal of Wind Engineering and Industrial Aerodynamics
27 March 2007 in Journal of Applied Polymer Science
1 January 2019 in Experimental Eye Research
MMMohamad Najib Bin Misri
SSShahrulzaman Shaharuddin
+2
1 April 2012 in Journal of Fluids and Structures
1 January 2007 in Express Polymer Letters
The effect of bar sealing parameters on the heat seal strength of oriented polypropylene (OPP)/metallic cast polypropylene (MCPP) laminate film was investigated. Based on the results obtained from the parametric study, a bar seal- ing process window was developed. All points drop within the process window are combinations of platen temperature and dwell time that produce acceptable heat seal. Optimum combinations are indicated by the lower border of the window. The plateau initiation temperature, Tpi of OPP/MCPP laminate film used in the present study occurred before the final melting temperature, Tmf of the sealant material. The highest achievable heat seal strength was at the plateau region, and the corre- sponding failure modes were delaminating, tearing or combine failure modes (delaminating and tearing). Minimum pres- sure level of 1.25 bars is necessary to bring the laminate interface into intimate contact in order to effect sealing.