This study provides a pore-scale investigation of two-phase flow dynamics during primary drainage in a realistic heterogeneous rock sample. Using the lattice Boltzmann (LB) method, a series of three-dimensional (3D) immiscible displacement simulations are conducted and three typical flow patterns are identified and mapped on the capillary number (Ca)-viscosity ratio(M) phase diagram. We then investigate the effect of the viscosity ratio and capillary number on fluid saturation patterns and displacement stability in Tuscaloosa sandstone, which is taken from the Cranfield site. The dependence of the evolution of saturation, location of the displacement front, 3D displacement patterns and length of the center of mass of the invading fluid on the viscosity ratio and capillary number have been delineated. To gain a quantitative insight into the characteristics of the invasion morphology in 3D porous media, the fractal dimension Df of the non-wetting phase displacement patterns during drainage has been computed for various viscosity ratios and capillary numbers. The logarithmic dependence of Df on invading phase saturation appears to be the same for various capillary numbers and viscosity ratios and follows a universal relation.
Coupled effects of wettability and pore geometry on pore‐scale dynamics of immiscible two‐phase fluid displacement were investigated using a multiphase lattice Boltzmann model in homogeneous and heterogeneous porous media under a wide range of contact angle θ (25° ≤θ≤ 175°). The observed invasion patterns indicate that the complex interactions between wettability and pore morphology play crucial roles in controlling the displacement patterns. The detailed pore‐scale analysis enabled us to delineate how wettability influences the recovery efficiency of the defending fluid in homogeneous and heterogeneous porous media. As the wetting condition changes from strong drainage to imbibition, we observed a transition from burst to corner flow leading to a compact displacement and hence a higher recovery efficiency in the heterogeneous sample. The present study sheds new insights on how the interaction between wettability and heterogeneity influences fluid displacement in porous media.
This study evaluates the potential of carbon dioxide-enhanced oil recovery (CO2-EOR) to reduce greenhouse gas emissions without compromising oil production goals. A novel, dynamic carbon lifecycle analysis (d-LCA) was developed and used to understand the evolution of the environmental impact (CO2 emissions) and mitigation (geologic CO2 storage) associated with an expanded carbon capture, utilization and storage (CCUS) system, from start to closure of operations. EOR operational performance was assessed through CO2 utilization rates, which relate usage of CO2 to oil production. Because field operational strategies have a significant impact on reservoir engineering parameters that affect both CO2 storage and oil production (e.g., sweep efficiency, flood conformance, fluid saturation distribution), we conducted a scenario analysis that assessed the operational and environmental performance of four common and novel CO2-EOR field development strategies. Each scenario was evaluated with and without stacked saline carbon storage, an EOR/storage combination strategy where excess CO2 from the recycling facility is injected into an underlying saline aquifer for long-term carbon storage. The dynamic interplay between operational and environmental performance formed the basis of our CCUS technology analysis. The results showed that all CO2-EOR evaluated scenarios start operating with a negative carbon footprint and, years into the project, transitioned into operating with a positive carbon footprint. The transition points were significantly different in each scenario. Water-alternating-gas (WAG) was identified as the CO2 injection strategy with the highest potential to co-optimize EOR and carbon storage goals. The results provide an understanding of the evolution of the system’s net carbon balance in all four field development strategies studied. The environmental performance can be significantly improved with stacked storage, where a negative carbon footprint can be maintained throughout the life of the operation in most of the injection scenarios modelled. This information will be useful to CO2-EOR operators seeking value in storing more CO2 through a carbon credit program (e.g., the 45Q carbon credit program in the USA). Most importantly, this study serves as confirmation that CO2-EOR can be operationally designed to both enhance oil production and reduce greenhouse gas emissions into the atmosphere.
27 November 2013 in Greenhouse Gases: Science and Technology