25 November 2023 in Measurement
14 July 2023 in IEEE Transactions on Instrumentation and Measurement
Touch-trigger probes (TTPs) have been commonly utilized in on-machine measurement (OMM) by virtue of their low cost and high repeatability. The pre-travel error (PTE) compensation of the probe is one of the critical issues in improving OMM precision. The majority of existing studies on PTE compensation in five-axis OMM adopt the same strategy as in three-axis OMM. Thus, the discrepancies between the two measurement processes and PTE compensation principles are ignored, which results in poor compensation accuracy for the five-axis measured results. In this paper, a novel PTE compensation strategy is presented to accurately compensate for the five-axis OMM results. Due to the limitations of the PTE map formed by the calibrated positions on the standard sphere for application in five-axis measurement, a PTE map represented by the touch positions on the stylus tip is developed. As a result, the exact mapping relationships between the touch positions on the stylus tip and the PTEs in five-axis OMM can be constructed. Then, the calculations of the PTE compensation component (PTECC) in three-axis OMM and five-axis OMM are discussed and compared. Specially, the positioning deviations of rotary axes are also considered in the proposed strategy to compensate for their influence on the measured results during the five-axis measurement. Finally, impeller inspection tests are performed to validate the effectiveness of the proposed compensation strategy for five-axis OMM, and more than 20% inspection precision improvement is observed.
11 May 2020 in The International Journal of Advanced Manufacturing Technology
10 January 2018 in The International Journal of Advanced Manufacturing Technology
19 May 2022 in Journal of Manufacturing Science and Engineering
As an important technology of adaptive machining, on-machine measurement (OMM) is always used to measure the shape of the to-be-cut surface. Due to the multi-source errors in an OMM system, the confidence of the measurement accuracy becomes particularly important before planning the next cutting procedure. OMM is implemented by multi-components involving machine tools, fixture, and on-machine probe. Each component introduces uncertainty of error into the measurement result. The positioning error, alignment error, and eccentricity error are investigated in terms of the expectation, uncertainty, and probability density function. By the kinematics of the components participated in the measurement, these errors are accumulated to affect the measurement results. Thus, the uncertainty of the final measurement result is determined by the accumulation of uncertainty of error sources. In order to evaluate the uncertainty of measurement error, an uncertainty propagation model involving positioning error of five-axis machine tools, alignment error of workpiece, and eccentricity error of the stylus tip is established in terms of the kinematic chain of OMM. Then, the uncertainty of the measurement result in vector form is obtained. Finally, the simulation and the experiment about the impeller are employed to validate the effectiveness and repeatability of the uncertainty propagation model for five-axis OMM.
19 October 2018 in Journal of Manufacturing Science and Engineering
In a new blade manufacturing process, manufacturers precisely forge blade billets with the blade suction and the pressure surfaces within tolerance. After that, only two blade edge billets should be machined to the leading- and the trailing-edges within tolerance. If these edge design surfaces are used to generate tool paths for machining the edge billets, the machined edges are not continuous with the suction and the pressure surfaces. To address this problem, an optimal approach to constructing process models of edge surfaces is proposed for adaptive blade machining. Specifically, the modified edge surfaces are optimized within the design tolerance and are continuous with the billet suction and pressure surfaces. These surfaces are used to generate tool paths for machining the edge billets. This approach addresses the current technical challenge in the new blade manufacturing process and can substantially promote this process in blade mass production.