Piotr Maj

Piotr Maj

Auto-generated profile, based on publicly available information

Piotr Maj

Instrumentation Department, Brookhaven National Laboratory, Upton, NY 11973-5000, U.S.A.

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 April 2016 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Open access
PGP. Grybos
P. Grybos
PKP. Kmon
P. Kmon
PMP. Maj
P. Maj
RSR. Szczygiel
R. Szczygiel
This paper presents a readout integrated circuit called UFXC32k, designed for hybrid pixel semiconductor detectors used in X-ray imaging applications. The UFXC32k integrated circuit, designed in a CMOS 130 nm process, contains about 50 million transistors in the area of 9.64 mm × 20.15 mm. The core of the IC is a matrix of 128 × 256 square-shaped pixels of 75 μm pitch. Each pixel contains a charge sensitive amplifier, a shaper, two discriminators, and two 14-bit ripple counters. The analog front-end electronics allow processing of sensor signals of both polarities (holes and electrons). The UFXC32k chip is bumpbonded to a pixel silicon sensor and is fully characterized using X-ray radiation. The measured equivalent noise charge for the standard settings is equal to 123 e - rms (for the peaking time of 40 ns) and each pixel dissipates 26 μW. Thanks to the use of trim blocks working in each pixel independently, an effective offset spread calculated to the input is only 9 e - rms with a gain spread of 2%. The maximum count rate per pixel depends mainly on effective CSA feedback resistance. Dead time in the front end can be set as low as 85 ns. In the continuous readout mode, a user can select the number of bits read out from each pixel to optimize the UFXC32k frame rate, e.g., for a readout of 2 bits/pixel with 200 MHz clock, the frame rate is equal to 23 kHz.

6 September 2012 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Verified
Journal Article
Closed access
PMP. Maj
P. Maj
PGP. Grybos
P. Grybos
RSR. Szczygiel
R. Szczygiel
MZM. Zoladz
M. Zoladz
TST. Sakumura
T. Sakumura
YTY. Tsuji
Y. Tsuji

18 June 2007 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
PGP. Grybos
P. Grybos
MIM. Idzik
M. Idzik
PMP. Maj
P. Maj
The noise of a fast charge sensitive amplifier (CSA) with an input MOS transistor operating in the moderate inversion region is discussed. The MOS transistor operation in the moderate inversion region becomes especially important in multichannel readout systems where limited power dissipation is required. The ENC of a CSA followed by a fast shaper is usually dominated by the voltage noise of the input MOS transistor. We carried out noise minimization for such a CSA, searching for an optimum input transistor width. The analyses were made using a simplified EKV model and were compared to HSPICE simulations using a BSIM3v3 model. We considered several CMOS technology generations with minimum transistor gate length ranging from 0.13 mum to 0.8 mum. We studied the sensitivity of ENC to the input transistor width, and propose a simple formula to estimate the optimum transistor width, which is valid in a wide current density range.

2 July 2021 in Science Advances
Verified
Journal Article
Open access
PDF file
MUMythreyi Unni
Mythreyi Unni
SSShehaab Savliwala
Shehaab Savliwala
BPBrittany D. Partain
Brittany D. Partain
LMLorena Maldonado-Camargo
Lorena Maldonado-Camargo
QZQingteng Zhang
Qingteng Zhang
CRCarlos M. Rinaldi-Ramos
Carlos M. Rinaldi-Ramos
Polymer-coated nanoparticles in synovial fluid and hyaluronic acid solutions diffuse faster than expected based on bulk viscosity.

29 January 2015 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
PMP. Maj
P. Maj
PGP. Grybos
P. Grybos
RSR. Szczygiel
R. Szczygiel
PKP. Kmon
P. Kmon
RKR. Kleczek
R. Kleczek
GDG. Deptuch
G. Deptuch
The paper presents a prototype integrated circuit built in a 40 nm CMOS process for readout of a hybrid pixel detector. The core of the IC constitutes a matrix of 18 ×24 pixels with the pixel size of 100 μm ×100 μm. The paper explains the functionality and the architecture of the IC, which is designed to operate in both the standard single photon counting mode and the single photon counting mode with interpixel communication to mitigate negative effects of charge sharing. This article focuses on the measurement results of the IC operating in the standard single photon counting mode. The measured ENC is 84e - rms (for the peaking time of 48 ns), the gain is 79.7 μV/e - , while the effective threshold dispersion is 21e - rms.

25 October 2017 in Physical Review Letters
Verified
Journal Article
Open access
PDF file
QZQingteng Zhang
Qingteng Zhang
DBDivya Bahadur
Divya Bahadur
EDEric M. Dufresne
Eric M. Dufresne
PGPawel Grybos
Pawel Grybos
PKPiotr Kmon
Piotr Kmon
ASAlec Sandy
Alec Sandy
We have examined the formation and dissolution of gels composed of intermediate volume-fraction nanoparticles with temperature-dependent short-range attractions using small-angle x-ray scattering, x-ray photon correlation spectroscopy, and rheology to obtain nanoscale and macroscale sensitivity to structure and dynamics. Gel formation after temperature quenches to the vicinity of the rheologically determined gel temperature, Tgel, was characterized via the slowdown of dynamics and changes in microstructure observed in the intensity autocorrelation functions and structure factor, respectively, as a function of quench depth (ΔT=Tquench−Tgel), wave vector, and formation time tf. We find the wave-vector-dependent dynamics, microstructure, and rheology at a particular ΔT and tf map to those at other ΔTs and tfs via an effective scaling temperature, Ts. A single Ts applies to a broad range of ΔT and tf but does depend on the particle size. The rate of formation implied by the scaling is a far stronger function of ΔT than expected from the attraction strength between colloids. We interpret this strong temperature dependence in terms of cooperative bonding required to form stable gels via energetically favored, local structures.