1 January 2019 in Journal of Aerospace Engineering
Hypersonic vehicles have attracted lasting and worldwide attention in recent years. Considerable aerodynamic drag and severe aerothermal loads are major challenges for hypersonic vehicles. A novel combinational aerodisk and lateral jet concept is proposed for drag reduction and thermal protection in hypersonic flows. The flow field characteristics have been numerically investigated with in-house code. The Reynolds-averaged Navier-Stokes (RANS) equations were adopted to simulate the flow field, and the shear stress transport (SST) turbulence model was used to present the turbulent nature. Fluid–thermal interaction is also taken into consideration in this paper. The influences of the lateral jet pressure ratio and its location on the flow field have been thoroughly studied using numerical methods. The obtained results demonstrate that the novel concept is beneficial for drag reduction and thermal protection in hypersonic flows. Increasing the lateral jet pressure ratio can further improve drag reduction performance. In addition, the heat flux can be significantly reduced by increasing the lateral jet pressure ratio. The lateral jet location also has important effects on the flow properties. The peak values of the Stanton number and wall static pressure can even be reduced by 19.76% and 22.15%, respectively, with different lateral jet locations.
16 January 2019 in International Journal of Turbo & Jet-Engines
The experiment system of pulse detonation engine is set up to investigate the acoustic signature of detonation acoustic. The research on detonation acoustic characteristic of pulse detonation engine in three kinds of working states, deflagration stage, detonation stage and external detonation stage, is carried out. Results from the test show that the maximal PImpact, PJet1, τ+ and τInterval are obtained in external detonation stage. In deflagration stage, the concentrate of PDE acoustic signal energy is obvious. The energy of impulsive rise of impact noise and jet noise is an important part of PDE acoustic in deflagration stage. In detonation stage, a concentration of energy distribution is appeared in low frequency, and the energy of medium-high frequency is decreased. In external detonation stage, energy distribution is more concentrated in low frequency. The value of η11/η5 can be used to detect the working state of pulse detonation engine. When η11/η5 is less than 5, pulse detonation engine is in deflagration stage, however, when η11/η5 is large than 5, pulse detonation engine is in detonation stage or external detonation stage.
2 July 2020 in International Journal of Turbo & Jet-Engines
The experiment system of pulse detonation engine is set up to investigate on influence of diameter on detonation acoustic characteristic. The research of detonation acoustic characteristic of pulse detonation engine for four different diameters in different angles is carried out. Results from the test show that as the PDE diameter increasing, there are increases in amplitudes of impact noise in all angles, and the growth rate of amplitude of impact noise in the 90° direction is generally greater than that in the 0° direction. The smaller PDE diameter is, the distance of most obvious directivity at 0° turning to most obvious directivity at 30° is shorter. When the distance is shorter, such as 200 mm, the duration of detonation acoustic is increasing with the increase of PDE diameter, however, when the distance is longer, such as 3000 mm, it is just the opposite. The maximum duration of detonation acoustic is appeared in 3000 mm under 30 mm PDE diameter which reaches to 1.44 ms.