21 December 2023 in Applied Thermal Engineering
1 February 2024 in Chemical Engineering Research and Design
1 January 2023 in Physics of Fluids
The focus of this paper is on the effect of velocity and radius distribution on jet breakup. A theoretical model is established to analyze and predict the velocity distribution along the jet, which is physically and mathematically continuous. The simplified forms of the breakup time, the disturbance growth rate, and the disturbance level considering the velocity and radius distribution are presented. A series of prediction methods for predicting the jet breakup length and droplet size are developed. A Newtonian laminar jet falling vertically was experimentally observed to validate the theoretical model and prediction methods. It is shown that the relaxation of the velocity profile leads to the rapid contraction of the jet radius near the outlet, which leads to the increase in the growth rate of the instability disturbance. The surface tension prevents the growth rate of disturbance from increasing by restraining the contraction of jet radius. The final amplification of jet velocity and contraction due to gravity acceleration depend on the Froude number and breakup length. When the influence of jet radius distribution on the growth rate of disturbance is considered, the breakup time is indirectly affected by the breakup length. The experimental and predicted results show that the accelerated falling of jet lengthens the breakup length traveled by the jet in a shortened breakup time due to the contraction of jet radius. The droplet volume is proportional to the predicted jet cross-sectional area at the breakup position and the Rayleigh wavelength determined by the nozzle radius.
1 September 2024 in Physics of Fluids
The free liquid sheet formed by jet impingement often has a certain bending, and this paper focuses on the influence of this bending on the rim dynamics and instability. The derivations of the rim retraction and the flow trajectory of the curved liquid sheet show that the length of the flow trajectory reaching the equator is the same as the Taylor–Culick radius representing the rim retraction equilibrium. It is inferred that the stable radius corresponding to the curved trajectory must be less than the Taylor–Culick radius, that is, a curved liquid sheet cannot reach the stable position by the rim retraction equilibrium alone. Experimental results confirm that the greater the degree of liquid sheet bending, the farther the stable radius from the Taylor–Culick radius. In addition to the rim retraction, the rim can remain in a stable position with the help of the fingerlike cusp, formed due to instability, deflecting liquid momentum. The dispersion equation of rim instability is derived to obtain the maximum growth rate of disturbance and corresponding wavelength. The surface tension is the main driving force of rim instability, and the liquid flow from the liquid sheet into the rim inhibits the rim instability. With increasing We, the decreasing local liquid sheet thickness increases the growth rate of disturbance and decreases the instability wavelength, which causes the rim to destabilize at a smaller rim radius, resulting in the corresponding decrease in droplet radius. The experimental results agree well with the theoretical prediction.
1 June 2024 in Physics of Fluids
The focus of this paper is on the spreading characteristics of the liquid sheet formed by jet impinging on a circular plane. The liquid sheet is studied in two parts: the liquid film that spreads radially on the circular plane, and the free liquid sheet after leaving the circular plane, the former determines the initial thickness and velocity of the latter. Experimental results show that, for the liquid film on the circular plane part, as the jet velocity increases, the liquid film thickness increases due to the film velocity loss caused by the inelastic collision. The liquid film thickness is positively correlated with the jet radius and negatively correlated with the circular plane radius. Liquid viscosity slows the spreading of liquid film, forms the boundary layer, and thickens the liquid film. The surface tension inhibits the velocity loss due to the inelastic collision. For the free liquid sheet part, surface tension and gravity promote the bending of the liquid sheet. The larger the initial momentum of the liquid sheet leaving the circular plane, the larger the maximum spreading range of free liquid sheet reaching the equator. As for the theoretical model, a film velocity correction coefficient reflecting collision loss is introduced to improve the radial spreading theory of the liquid film on a solid surface, and a streamline function is assumed to solve the momentum integral equation of free liquid sheet. The predicted streamline agrees well with the experimental data.