Polymer crystals grown from melts consist of alternating lamellar crystalline regions and amorphous regions. We study the statistics of ties: chains which bridge the adjacent lamellae, loops: chains which come out of one lamella and enter back into the same lamella before reaching the other lamellae, and tails: chains which end in an amorphous region. We develop a theory to calculate the probabilities of formation of ties, loops, and tails with consideration of finite chain length and cooperative incorporation of a chain into multiple lamellae. The results of our numerical calculations based on a field-theoretic formalism show that the fraction of ties increases with increasing chain length, and it decreases with increasing interlamellar separation. In the limiting case of an infinite chain confined between only two walls, we recover the classical results of the gambler’s ruin model. We show that the density anomaly encountered in previous theories is avoided naturally in the present theory without forcing the majority of stems to form tight loops. The derived results on the probability of tie chains in the amorphous regions are pertinent to the mechanical properties of semicrystalline polymers.
Recent experiments on melts of spherical nanoparticles (NPs) densely grafted with polymer chains show enhanced gas transport relative to the neat polymer (without NPs). Simulations on such systems do not reproduce these experimental trends. As a means of understanding this unexpected behavior, here we consider the simpler case of two interacting planar brushes, under conditions representing a polymer melt far below its critical point (i.e., where the “free volume” or holes act akin to a poor solvent). Computer simulations illustrate, in agreement with mean-field ideas, that the density profile far away from the walls is flat but with a value that is marginally larger than that of the corresponding polymer melt under identical state conditions. We find that tracer particles, which represent the gas of interest, segregate preferentially to the grafting surface, with this result being relatively insensitive to the nature of polymer–surface interactions. These brush layers therefore correspond to heterogeneous transport media: gas molecules near the grafting surface have accelerated dynamics (presumably parallel to the wall) relative to the corresponding polymer melt, but they have slower dynamics in the central region of the brush. We therefore find that gas molecules perform hop-like motions—they spend a significant part of their time in the regions of fast transport, separated by motions where they “hop” from one surface to the other. These phenomena in combination lead to an overall speedup in gas dynamics in these brush layers relative to a polymer melt, in good agreement with the experimental data.
Recent experimental work has shown that polymer crystallisation can be used to “move” and organize nanoparticles (NP). As a first effort at modeling this situation, we consider the classical Stefan problem but with the modification that polymer crystallisation does not occur at a single temperature. Rather, the rate of crystallisation is proportional to its subcooling, and here we employ a form inspired by the classical Avrami model to describe this functional form. Our results for the movement of the polymer crystallisation front, as defined as the point where the crystallinity is 50%, closely track the results of the classical Stefan problem. Thus, at this level of approximation, the crystallisation kinetics of the polymer do not cause qualitative changes to the physics of this situation. Inspired by this fact we study the more interesting situation where the directional recrystallisation of a polymer melt is considered, e.g., through the application of a moving heat sink over an initially molten polymer, reminiscent of a processing technique termed zone annealing. The polymer crystallisation shows that a steady state exists for a range of sink velocities. The solid–melt interface moves slightly ahead of the sink but at the same velocity. The steady-state distance between the sink and the interface decreases with increasing sink velocity – this is a consequence of the excess cooling provided by the sink over what is required to crystallise the melt. The most interesting new result is that the temperature of the crystal–melt interface decreases with increasing sink velocity. This is in line with the ansatz of Lovinger and Gryte who suggested that larger zone annealing velocities correspond to progressively larger effective undercoolings at which polymer crystallisation occurs.
We develop a boundary layer solution for directional polymer crystallisation providing a clearer understanding of nearly fifty years old polymer zone annealing experiments.