The purpose of this paper is to present a maintenance study focused on total productive maintenance (TPM) and reliability-centered maintenance (RCM). Its approach is based on the first pillars of TPM, preventive and autonomous maintenance, as well as the FMEA analysis of RCM for maintenance analysis, which was conducted in this study. The implementation of TPM was successful in that various preventive maintenance (PM) policies assigned to the assets were implemented and it was demonstrated that TPM application in the construction industry could reduce the excessive accumulation of maintenance with the same effective optimization, and with support from RCM analysis and its heavy equipment systems analysis. Excessive corrective maintenance accounts for high investment and delay rates in work times of the assigned project. Traditional methods of availability guarantee, such as reactive or routine maintenance, are insufficient to satisfy a heavy equipment maintenance plan; therefore, what is called for is the systematic application of RCM and TMP because they allow the selection and application of effective PM tasks. An approach that develops and thoroughly analyzes the strategies of continuous corrective and PM is used with an atmosphere of uncertainty and with operational data limited by criticism. Results show a 90% improvement in availability.
Worldwide, the production of plastics has maintained remarkable growth in recent years. Since its emergence in the 1950s, it has maintained an exponential trend, due to the fact that products made from this material are adapted to different uses, such as containers, packaging, toiletries, etc. Thermoforming is one of the plastic forming techniques, this process is largely automated, so it is vitally important to keep the machines operational most of the time. There are studies that show that low machine availability can be caused by long setup times and downtime due to equipment breakdowns. In this sense, the purpose of this research is to identify, study and solve the main causes that generate the problem of low availability in the thermoforming line of a plastic industry in Peru, since they represent high expenses for the company due to penalties for delays in the delivery of orders and additional consumption. To solve this problem, the implementation of Lean Manufacturing tools such as Single-Minute Exchange of Die (SMED), Total Productive Maintenance (TPM; Autonomous Maintenance and Planned Maintenance) and Standardized Work is proposed to increase line availability by 10%. and stay competitive in the market. This model was validated through a simulation method in the Arena software where three solution scenarios were established. After validating the model, it is concluded that the availability of machines can be increased from 80% to 93% by implementing these tools and having an optimistic scenario. In addition, the setup time indicator decreased from 56.25 minutes to 22.3 minutes, the programming time by non-standardized parameters decreased to 13.99 minutes, the number of stops due to breakdowns per year was reduced by 40.7% and the MTBF (Mean Time Between breakdowns) increased to 158.5 hours. Finally, it was possible to demonstrate economically that the project is viable, since the IRR (Internal Rate of Return) is greater than the Opportunity Cost (COK) and the Net Present Value (VAN) is greater than zero.
The research develops a PDCA model proposal for products warehouse management in a company belonging to the Peruvian retail pharmaceutical sector to optimize inventory management. This is due to the identification of the main problem, which is the low annual inventory turnover during the last year, which has a value of 2.10. This problem in question represents a technical gap in the annual inventory turnover rate of 2.86 with respect to the average between research articles and an organization established in Peru; and a negative economic impact, which represents 11.81% of the annual income for 2021. Based on the literature review, the contribution of this project consists of the development of an ABC analysis, optimization methods and process control such as the 5S methodology, Kanban tool and cycle counting. The main results obtained were the increase in the annual inventory turnover rate by 3.94, the decrease in the percentage of products not located by 0.80%, the decrease in the percentage of products in poor condition by 2.79% and the increase in the accuracy of registration at 97.21%. The research work showed that the integration of Lean Manufacturing tools, through a PDCA model, will achieve a broader solution to the problems generated by poor warehouse and inventory management.