13 April 2023 in ACM Transactions on Internet of Things
In many real-world wireless IoT networks, the application dictates the location of the nodes and therefore the link characteristics are inhomogeneous. Furthermore, nodes may in many scenarios only communicate with the Internet-attached gateway via multiple hops. If an energy-efficient short-range modulation scheme is used, nodes that are reachable only via high-path-loss links cannot communicate. Using a more energy-demanding long-range modulation allows connecting more nodes but would be inefficient for nodes that are easily reachable via low-path-loss links. Combining multiple modulations is challenging, as low-power radios usually only support the use of a single modulation at a time. In this article, we present the Long-Short-Range (LSR) protocol which supports low-power multi-hop communication using multiple modulations and is suited for networks with inhomogeneous link characteristics. To reduce the inherent redundancy of long-range modulations, we present a method to determine the connectivity graph of the network during regular data communication without adding significant overhead. In simulations, we show that LSR allows for reducing power consumption significantly for many scenarios when compared to a state-of-the-art multi-hop communication protocol using a single long-range modulation. We demonstrate the applicability of LSR with an implementation on real hardware and a testbed with long-range links.
27 October 2021 in ACM Transactions on Internet of Things
Testbeds for wireless IoT devices facilitate testing and validation of distributed target nodes. A testbed usually provides methods to control, observe, and log the execution of the software. However, most of the methods used for tracing the execution require code instrumentation and change essential properties of the observed system. Methods that are non-intrusive are typically not applicable in a distributed fashion due to a lack of time synchronization or necessary hardware/software support. In this article, we present a tracing system for validating time-critical software running on multiple distributed wireless devices that does not require code instrumentation, is non-intrusive and is designed to trace the distributed state of an entire network. For this purpose, we make use of the on-chip debug and trace hardware that is part of most modern microcontrollers. We introduce a testbed architecture as well as models and methods that accurately synchronize the timestamps of observations collected by distributed observers. In a case study, we demonstrate how the tracing system can be applied to observe the distributed state of a flooding-based low-power communication protocol for wireless sensor networks. The presented non-intrusive tracing system is implemented as a service of the publicly accessible open source FlockLab 2 testbed.