A dynamic model is developed for a small, highspeed autonomous underwater vehicle. The vehicle has the unusual property of weighing up to 50 percent more than its displacement, and we seek to characterize requirements for steady-state flight imposed by the vehicles's weight. The process of deriving a dynamic model, which is presented in a tutorial manner, highlights problems that arise when the dynamics of a submersible are expressed in terms of linear and angular momenta and combined with experimentally derived hydrodynamic coefficients
This paper presents an system identification algorithm for the longitudinal motion of a streamlined, tail-controlled, miniature autonomous underwater vehicle (AUV). The motion of a rigid body in six degrees of freedom is restricted to the dive plane to derive a fourth order dynamic pitch axis model. Based on the mechanical design of the vehicle, we impose symmetry and buoyancy assumptions that allow further model truncation. Basic dependencies between inherent stability of these truncated models and system parameters such as hydrodynamic coefficients are addressed. For the goal to rapidly design an AUV attitude control system, we experimentally show that it is sufficient to consider a second order dynamic model. We identify model parameters by matching the input and output behavior via least squares. Data collected during field trials validates both the system identification and the utility of a second order model for control design.
The question of using off-the-shelf model boat propellers in a counterrotating-pair configuration was addressed. A number of candidate propellers were performance tested in a water tunnel. Both open-water single-propeller tests and counterrotating-pair tests were performed. A model based on momentum theory was devised to predict the performance of the counterrotating pair from the individual single-propeller performance curves. Unknown coefficients in the model were determined by minimizing the deviation of the model from the counterrotating performance data. Excellent agreement between the model and the data was found over the entire range of the counterrotating pairs tested. The model can now be used to predict the thrust, net torque and efficiency of two off-the-shelf model boat propellers operating as a counterrotating pair.