25 July 2018 in IEEE Transactions on Circuits and Systems I: Regular Papers
In this paper, a dual-band transmission-line resistance compression network (TLRCN) is introduced and applied to the rectifier design to enhance the power conversion efficiency at low input power levels, leading to wider dynamic power range of the rectifier. It can be used to reduce the sensitivity of the rectifying efficiency to input power variation at two frequencies. The analytical expressions for the dual-band TLRCN are derived. In order to validate the proposed idea, two dual-band rectifiers with different frequency spacing (Δ f) are designed, fabricated, and measured. One works at 0.915 GHz/2.45 GHz (Δ f = 1.535 GHz) and the other at 1.80 GHz/2.40 GHz (Δ f = 0.6 GHz). For comparison, their counterparts, without the dual-band TLRCN, are also designed and implemented. The measured results show that the proposed dual-band TLRCN can be used to extend the input power range at two frequencies without decreasing the maximum power conversion efficiencies.
2 April 2020 in IEEE Transactions on Antennas and Propagation
This paper proposes gain-enhanced circular patch antenna and array with introduction of multiple shorting pins. The antenna consists of a circular patch and several shorting pins. Equivalent inductance is brought to the patch after introducing shorting pins. Thus, resonance of the patch shifts at higher frequency. Compare to a conventional circular patch without any pins, radiation area of the proposed patch is enlarged given the same resonance frequency, hence leads to gain enhancement. The number of pins introduced to a circular patch can be set freely due to its symmetrical feature. Moreover, surface current is restricted within a small area around the center of the patch after introducing multiple pins, leading to more concentrated radiation. An equivalent circuit model is built for the proposed antenna. Layout and number optimization rules for introducing shorting pins are formulated. With these rules, gain of a circular patch can be maximized for the applications under certain size restrictions. A prototype operating at 5.8 GHz is designed and fabricated. Furthermore, a 2*2 array based on the gain-enhanced circular patch elements is implemented. In the measurements, high gain, high efficiency and narrowed half-power beamwidth of the patch antenna as well as the array are observed.
4 February 2025 in IEEE Antennas and Wireless Propagation Letters
In this letter, a dual-band polarization reconfigurable (DBPR) rectenna is proposed for radio frequency energy harvesting (RFEH). This rectenna consists of a dual-band (2.4 and 5.8 GHz) polarization configurable antenna and a dual-band rectifier. For the radiating antenna element, its dual-band characteristic is achieved by adding short-circuit probes to stimulate two resonant modes (TM10 and TM30). Besides, we use a dual-band branch-line coupler and six PIN diodes as the antenna's feeding network. This antenna can be utilized to receive linear polarization (LP), left-hand circular polarization (LHCP) and right-hand circular polarization (RHCP) waves through turning the PIN diodes ON or OFF. For validation, a protype is fabricated and measured. The measured peak gain of the antenna at 2.4 and 5.8 GHz are 5.71 and 6.9 dBi, respectively. In addition, at 2.4 and 5.8 GHz, the rectenna achieves a 54% and a 44.4% peak power conversion efficiency (PCE). The designed rectenna can be used to construct a dual-band RFEH system with various polarization receiving capability.
1 August 2022 in IEEE Microwave and Wireless Components Letters
In this letter, a broadband rectifier with a wide-incident-angle (WIA) property is proposed. The circuit is composed of a broadband quadrature coupler (BQC) and two broadband subrectifiers (Rect $_{\mathrm{A}}$ and Rect $_{\mathrm{B}})$ . Here, Rect $_{\mathrm{A}}$ and Rect $_{\mathrm{B}}$ are connected to the two output ports of the BQC and combined by a direct current (dc) power combiner. Then, the obtained dc power is transmitted to the load resistor. Besides, two RF sources (RF $_{1}$ and RF $_{2})$ with identical input power and a phase difference ( $\Delta \varphi )$ are connected to the input and isolated ports of the BQC. A detailed theoretical analysis is carried out. To validate the proposed scheme, we design a broadband (1.6–2.8 GHz) WIA rectifier. Measurement results show that the power conversion efficiency (PCE) exceeded 60% in the frequency range from 1.6 to 2.8 GHz at 13.1 dBm of the input power. Additionally, at 2.45 GHz, the PCE varies in the range of 60.8% and 72.6% within the entire $\Delta \varphi $ range (0 $^{\circ}$ –360 $^{\circ})$ . Thus, the obtained PCE variation ( $\Delta \eta )$ is 11.8%. Considering its excellent broadband and WIA features, it is very suitable for high-efficiency radio-frequency (RF) energy harvesting (RFEH) systems.
18 December 2023 in IEEE Antennas and Wireless Propagation Letters
In this letter, a compact concurrent dual-band self-oscillating active integrated loop antenna is proposed. In the design, an active switching circuit is integrated and multiplexed into two RF channels of a modified loop radiator to achieve concurrent dual-band self-oscillation and pulse radiation in a small system size. Two capacitors are embedded in the loop radiator to block the DC paths without cutting off the RF oscillation and radiation channels, thereby ensuring that the DC power supply could charge the antenna. In this way, DC energy can be stored in the antenna during the charging phase and be converted to dual-band pulses during the radiation pahse. Experiments are carried out to validate the proposed design. The overall circuit size is only 0.03 $\lambda _{m}^{2}$ at the mean frequency of the two frequency bands.
23 August 2025 in Microelectronics Journal