Dileep Kumar

Dileep Kumar

Auto-generated profile, based on publicly available information

Dileep Kumar

Department of Electrical and Electronics Engineering, Motihari College of Engineering, Motihari, Bihar, India

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 May 2020 in IETE Journal of Research
Verified
Journal Article
Closed access
DKDileep Kumar
Dileep Kumar
RGRam Avtar Gupta
Ram Avtar Gupta
HTHarpal Tiwari
Harpal Tiwari
The modified single-ended primary inductor converter (SEPIC) reported in the literature has limitations namely, low static gain and high input current ripples. This resulted in poor efficiency with high switching losses and switching stress. Hence, in order to overcome the above-said limitations, this paper proposes a high static gain SEPIC converter with reduced input current ripple. The proposed converter resembles a split-inductor design consisting of three diodes and two inductors. The static gain of the converter is significantly improved while input current ripple gets reduced by using a split-inductor. Additionally, the low value of input current ripple causes minimal switching stress and switching losses. Hence, the efficiency of the proposed converter improves significantly. The working principle and theoretical analysis of the proposed converter is studied in detail for continuous, discontinuous and boundary conduction modes. Moreover, a small signal/transient analysis is also discussed to validate the feasibility as well as the stability of the proposed system using the transfer function approach. In order to validate the effectiveness of the proposed converter, a MATLAB/Simulink model has been designed. Further, a laboratory prototype has been developed and the experimental results obtained are in agreement with the simulated results.

8 May 2026 in Engineering Research Express
Verified
Journal Article
Closed access
SKSweta Kumari
Sweta Kumari
SCSurya Deo Choudhary
Surya Deo Choudhary
DKDileep Kumar
Dileep Kumar
MTMohammad Tabrez
Mohammad Tabrez
CCChandra Shekhar Singh Chandal
Chandra Shekhar Singh Chandal
SSSaket Kumar Singh
Saket Kumar Singh
A dual band circularly polarized coplanar waveguide - fed microstrip patch antenna consisting of four inverted L grounded strips near the corners and a multi-level vertical stack excited by a 50 Ω impedance microstrip feedline is proposed. The complete dimension of the proposed antenna is only 60 x 60 x 0.8 mm3. The Circular Polarization (CP) is achieved by embedding a pair of inverted - L grounded strips into the square slot and by altering the dimensions of vertical stub. The frequency bandwidth of the proposed antenna is achieved for two bands, from 2.79 GHz to 3.99 GHz with resonating frequency at 3.3 GHz and 3.5 GHz for 5G and WiMAX applications respectively and the other one is from 6.94 GHz to 8.28 GHz featuring a resonating frequency of 7.9 GHz, this design is primarily utilized for satellite communication within the lower X-band for fixed satellite service (FSS) uplink. The uplink frequency from Earth to satellite ranges from 7.9 GHz to 8.4 GHz, making it ideal for applications such as fixed satellite services uplink. VSWR ≤ 2dB is achieved for both the bands and axial ratio (AR) ≤ 3dB is from 2.85 GHz to 3.85 GHz and 7.85 GHz to 8.33 GHz respectively. Performance of the fabricated antenna is experimentally validated and its Return Loss, VSWR, Axial Ratio, Radiation Pattern, Gain, Radiation Efficiency, Surface Current are also observed.

12 November 2019 in International Journal of Emerging Electric Power Systems
Verified
Journal Article
Closed access
PDF file
DKDileep Kumar
Dileep Kumar
RGRam Avtar Gupta
Ram Avtar Gupta
HTHarpal Tiwari
Harpal Tiwari
Mitigation of commutation current ripple (CCR) in the brushless direct current (BLDC) motor drive using DC-DC converter based topologies are achieving widespread popularity. However, undesired alternating current (AC) components are presented in the DC-link voltage across the capacitor of the DC-DC converter which leads to a destabilization of the power supply during the commutation interval. In addition, undesired speed regulation and audible noise occur which deteriorates the motor performance. In order to encounter this problem, different conventional compensation techniques based on the low-pass filter (LPF) has been proposed. However, LPF requires a close relation between dynamic coupling and active compensation. In view of the limitation, this paper proposes a proportional-resonant (PR) compensator to stabilize the DC-link voltage. Performance of the PR compensator is tested on a combination of modified single-ended primary inductor converter (MSEPIC), DC-link voltage selector circuit is used in the proposed current ripple mitigation technique for BLDC motor drive. The PR compensator is utilized to stabilize the DC-link voltage whereas the DC-link voltage selector circuit is employed to achieve a regulated DC voltage from the MSEPIC converter for efficient current ripple suppression during the commutation interval. Simulation and experimental results verify the effectiveness of the proposed compensation scheme for current ripple mitigation technique of BLDC motor drive. The simulation and experimental results clearly reveal that the PR compensator effectively stabilized the DC-link voltage, which alleviates the CCR.

18 January 2021 in Journal of the Pakistan Medical Association
Verified
Journal Article
Open access
DKDileep Kumar
Dileep Kumar
MSMuhammad Suleman
Muhammad Suleman
MMMehreen Malik
Mehreen Malik
AAAdmin Admin
Admin Admin
We report mixed germ cell tumour, presented with acute kidney injury in an unmarried 22 years old Asian girl. Our case demonstrated an aggressive approach with multidisciplinary teamwork ascertained outstanding clinical outcome. She managed successfully for fertility-sparing surgery and three cycles of Bleomycin, Etoposide and Cisplatin (BEP) therapy. Patient’s pathophysiology returned to normal within weeks and she converted tumour-free. Furthermore, the three years follow up scans and biomarkers were evident for tumour negativity. Continuous...

7 October 2025 in IEEE Access
Verified
Journal Article
Open access
DKDileep Kumar
Dileep Kumar
VPVivek Prakash
Vivek Prakash
SSSachin Sharma
Sachin Sharma
AKAjay Kumar
Ajay Kumar
The brushless dc motor (BLDCM) drives are adversely affected by commutation current ripple (CCR), which leads to increased torque ripple and degraded performance. The DC-DC converter based-BLDCM drive topology is widely preferred to suppress CCRs. The improved characteristics such as low mechanical oscillation and stiff-speed regulation of BLDCM drives further introduces undamped AC signals termed as switching frequency harmonics (SFH) which results destabilization of DC-link voltage (DCLV). The different breeds of filter techniques have been recommended to stabilize the DCLV. However, the recommended filters are composed on the basic of concept of low pass filter (LPF) or band-pass filter (BPF). In addition, these filters require a precise coordination with active compensation, current reference and nonlinear interaction. In this context, a quasi-proportional-resonant-compensator (QPRC) has applied to stabilize the DCLV. The QPRC is investigated for an in-front zeta converter (IFZC) assisted-BLDCM drive. The IFZC primarily handles voltage regulation, while the QPRC is incorporated to suppress the SFH of the DCLV. A hardware prototype has been developed, and experimental results are presented to validate the effectiveness of the proposed stabilization strategy and design. The suggested compensation technique effectively stabilized the DCLV and improves the overall performance of the BLDCM drive.

23 April 2026 in International Journal of Circuit Theory and Applications
Verified
Journal Article
Closed access
DKDileep Kumar
Dileep Kumar
SCSurya Deo Choudhary
Surya Deo Choudhary
MTMohammad Tabrez
Mohammad Tabrez
SSSaket Kumar Singh
Saket Kumar Singh