14 October 2019 in E3S Web of Conferences
Storage tanks for petroleum products must comply with the requirements of technical, technological and environmental safety. The corrosion rate increases with prolonged storage of petroleum products in tanks. To prevent the destruction processes for reliable operation of tanks caused by metal corrosion some solutions are needed. Active formation of general sludge occurs in the storage of fuel oil, which contains corrosion-active substances, because of the incompatibility of fuels. The paper assesses the effect of total oil sludge in tanks on the corrosion process and on the reliability of tanks. Studies of the formation of a common sediment caused by incompatibility when mixing petroleum products are conducted. The paper proposes a solution which allows to reduce the formation of total oil sludge and to ensure reliable operation of reservoirs.
27 September 2017 in IEEE Access
In this study we introduce a novel method for reconstruction roller bearings vibration signals. As well as the sparse reconstruction algorithm, our approach is based on the Lasso via the Alternate Direction Multiplier Method (ADMM) and optimized by Least Square QR-factorization (LSQR), which takes the priority over the Basis Pursuit and Lasso in iterations and errors. First, we use the Discrete Cosine Transformation (DCT) to achieve sparse signals, then we compress signals by using the Gaussian random matrix, and finally we reconstruct the original signals with the Lasso-LSQR by using the ADMM. According to the results, vibration signals can keep sufficient reconstruction accuracy with high compressive ratio, which validates the effectiveness of the method for vibration signals.
19 October 2017 in IOP Conference Series: Earth and Environmental Science
The purpose of the article is to analyze and compare the data in order to contribute to the formation of an objective opinion on the issue of the growth of stress corrosion defects of the main gas pipeline. According to available data, a histogram of the dependence of defects due to stress corrosion on the distance from the compressor station was constructed, and graphs of the dependence of the accident density due to stress corrosion in the winter and summer were also plotted. Data on activation energy were collected and analyzed in which occurrence of stress corrosion is most likely constructed, a plot of activation energy versus temperature is plotted, and the process of occurrence of stress corrosion by the example of two different grades of steels under the action of different temperatures was analyzed.
19 October 2017 in IOP Conference Series: Earth and Environmental Science
Following the results of measurements of hardness, magnetizing force and the rate of ultrasonic longitudinal waves of 09G2S steel samples at various cyclic operating time values, there is a phenomenon of transformation from the normal law of speed distribution of these parameters in power-mode distribution. It shows the submission of the behavior of metal as a complex system to the theory of the self-organized criticality.
19 October 2017 in IOP Conference Series: Earth and Environmental Science
Materials on methods for diagnostics and repair of centrifugal oil transfer pump rotor shaft are considered. Results of research on reconditioning worn-out pump shaft journals are presented with provision of surface low roughness by a method of mechanical and ultrasound surface ruggedizing final finish. Analysis of the results attained by the ultrasound ruggedizing finish of a pump shaft and inspection of the superficial layer quality has shown the method, when applied, to considerably increase equipment availability, reliability, and serviceability.