1 November 2019 in Transactions of Nonferrous Metals Society of China
25 March 2019 in Advances in Materials and Processing Technologies
Composite reinforcement manufacturing is gaining the attention of many researchers because it enhances the physical and chemical properties of the material that it is reinforced into. In this research, friction stir processing (FSP) was used to modify the surface by reinforcing titanium dioxide on aluminium alloy AA 5052. In this process, a square pin of length of edges of 6 mm was used. The experiment was done under variable parameters, namely, speed of the spindle rotation, processing feed rate on the milling machine and groove width of the sample. The groove on aluminium alloy was made to store the nanoparticles before FSP. The resultant reinforced material had increased mechanical properties compared to the aluminium alloy without FSP. This was due to the presence of hard particles. Titanium dioxide nanoparticles were seen in the grain structure of the aluminium alloy which enhanced the properties of the material surface. This research was done to study the manufacturing process and the material integrity for various applications.
1 November 2016 in Materials Science Forum
In this study, the effect of process parameters on microstructure and mechanical properties of friction stir welded aluminium matrix composites (AMC) have been explored. The results indicated that the recrystallized grain size at the bottom of the weld region is smaller than that at the top region due to difference in the heat transfer at the weld region. The joint strength of AMCs depends on proper selection of process parameters like tool rotational speed and welding speed. If process parameter values are beyond the optimal value, the joint strength decreases due to formation of defects. Maximum tensile strength is obtained for rotational speed of 1000 rpm and welding speed of 80mm/min.
27 June 2018 in IOP Conference Series: Materials Science and Engineering
7 October 2021 in Welding in the World
This paper explicates the joining of AA 6061/TiO2 composites by the friction stir welding (FSW) process. FSW experiments were conducted as per the three factors, three-level, central composite ivy– face-centered design method. Mathematical relationships between the FSW process parameters, namely tool geometry, welding speed, and tool rotational speed, and the output responses such as hardness, yield strength, and ultimate tensile strength were established using response surface methodology. Adequacies of established models were assessed through the analysis of variance method. Further, the paper elucidates the application of the teaching–learning-based optimization (TLBO) algorithm to identify the optimal values of input variables and to obtain an FSW joint with superior mechanical properties. The optimized experimental condition obtained from the TLBO yields an FSW joint with a UTS of 174 MPa, yield strength of 120 MPa, and hardness of 126HV. The study revealed that the result of the TLBO algorithm matched the findings of the FSW experiments.
13 March 2019 in Materials Research Express
Present study explores the Friction stir welding (FSW) of rutile reinforced AA6061matrix composite using various combination of tool traverse speeds (60, 75 and 90 mm/min), rotational speeds (750, 1000 and 1250 rpm) and tool pin profiles (Threaded cylindrical and Square profiled pin). FSW process variables have significant impact in controlling the mechanical properties of the joint by limiting the welding defects. It has been inferred from the study that tool rotational speed and tool traverse speed majorly affects the microstructure, joint quality, hardness and joint strength. The weld area showed the presence of four distinct regions usually found in FSW of aluminium matrix composites. The weld region exhibited fine equiaxed grains and uniformly distributed tiny reinforced rutile particles. Tool having square profiled pin shows improved joint properties in comparison with tool having threaded cylindrical pin.