1 January 2012 in European Journal of Control
This paper investigates control systems in which the number of actuators activated for performing control task at any time is limited. The activation status of the actuators is assigned in accordance to a random event (modeled by a Markov chain). Then under what condition is the system stable and how to design a controller to meet certain performance requirement? By taking into account the Markov chain and the transmission delay in the control signal, we establish a novel framework for stability analysis and controller synthesis. Specifically, a easily testable mode- and delay-dependent controller design method is given for uncertain linear systems. A numerical example is provided to show the advantage and usefulness of the proposed method.
18 December 2018 in IEEE Access
2 February 2021 in IEEE Transactions on Energy Conversion
This article is concerned with the issue how to achieve proportional current sharing while realizing bus voltage balancing in DC microgrids, or vice versa. In order to address this issue, proportional current sharing is realized first and then the optimal bus voltage is obtained by using the least square method; Second, assuming that the bus voltage balancing is realized, the optimal current sharing is solved by using Lagrange multiplier method. It can be seen that the results of the two cases are identical. Then a global performance index relating to the generation capacities is presented to make an optimal decision on voltage balancing and current sharing. In order to decrease the communication burden, the distributed control schemes are proposed to replace centralized control strategies. It can be proved that the equilibrium points of distributed schemes are completely identical to the optimal solutions without significantly increasing system complexity. Finally, the effectiveness of the proposed distributed schemes is shown via a simulation example.
1 June 2016 in International Journal of Control, Automation, and Systems
22 May 2024 in IEEE Sensors Journal
Security robots often operate in environments characterized by low light and smoke, where millimeter-wave radar proves effective. However, the millimeter-wave radar’s point cloud is often sparse and noisy, potentially leading to positioning failure when employing point cloud matching. In this paper, we propose a localization strategy for security robots based on millimeter wave radar. The position of the security robot is deduced by clustering and tracking the sparse point cloud. In addition, radial velocity was used to design an adaptive tracking threshold, so that the targets in the two frames of data are within the tracking threshold regardless of the fast or slow motion speed of the security robot. Experimental results indicate that this method circumvents positioning failures associated with point cloud matching. In comparison to the radial velocity method, this approach enhances positioning accuracy by approximately 33.9%. Additionally, compared to the fixed tracking association threshold, this method exhibits a higher success rate in target tracking, leading to a 25.9% improvement in security robot positioning accuracy.
24 August 2021 in IEEE Access
This paper is concerned with the dynamic output feedback control issue for a class of networked control systems with medium access constraints, network-induced delays and packet dropouts. It is assumed that the medium access constraints at both sides of the controller obey the Markov distribution, the upper bound of the network-induced delays is less than one sampling period, and the packet dropouts of networked channels can be described by i.i.d Bernoulli distribution processes. Then, the networked control systems are modelled as a class of asynchronous dynamic systems. According to Lyapunov stability theory and switching system theory, the dynamic output feedback controller is designed to guarantee the exponential stability of networked systems with the given decay rate. Finally, an illustrative example is provided to demonstrate the effectiveness of the proposed method.