1 October 2021 in Optical Materials
28 December 2022 in Beilstein Journal of Nanotechnology
ITO/Mo bilayer thin films were sputtered on n-type silicon and glass substrates and annealed with a Nd:YAG pulsed laser. The structural results show that both the as-deposited and the annealed ITO/Mo thin films have a polycrystalline structure, and that the annealing treatment enhanced the crystallinity of samples. Moreover, the XRD patterns exhibited a cubic structure preferentially oriented along the (222) and (400) planes. The AFM analysis shows that grain size and RMS roughness increased from 16.02 to 36.19 nm and 0.4 to 2.6 nm, respectively, when the laser energy was increased to 120 mJ. The as-deposited sample has an optical transmittance of nearly 80% in the 300–800 nm range. The laser annealing yielded a higher transmittance of 94% and increased the bandgap energy from 2.76 to 2.88 eV at 120 mJ. The annealing treatment decreased the resistivity from 15.63 × 10−4 to 1.73 × 10−4 Ω/cm−1. Additionally, the figure of merit of the ITO/Mo structure improved significantly from 6.63 × 10−4 Ω−1 of the as-deposited sample to 17.6 × 10−3 Ω−1 of the the annealed structure. The results indicate that the laser annealing could improve the efficiency of the transparent conductive layer, which can be potentially applied in optoelectronic devices.
10 November 2024 in Solar Energy
1 October 2023 in Surfaces and Interfaces
1 January 2023 in SSRN Electronic Journal
A novel laser annealing treatment was used to enhance the optoelectronic, and morphological properties of ITO/Cr-Ag/ITO (ICAI) thin film is presented. The multilayer thin film was deposited using RF magnetron sputtering technique and annealed using Nd:Yag laser. The ICAI properties were characterized using X-rays diffraction, atomic force microscope, field emission scanning electron microscope, energy dispersive X-ray, UV-Visible spectroscopy, four and two-probe point probe. These techniques show the high quality of the thin film and the improvement of the properties caused by the laser annealing. The XRD shows that laser annealing improves the crystalline quality of the film. The AFM and FESEM exhibit uniform and high surface quality, where the roughness was decreased, and the grain size was enlarged. The optical transmittance was increased from 80 to 90%, similar to the bandgap from 2.8 to 3.1 eV. The electrical measurements show a significant decrease in the resistivity, and an Ohmic contact improved with laser annealing. The annealed structure has recorded a very high figure of merit of 174×10-3 Ω-1. These results demonstrate that laser annealing treatment significantly enhances the thin film properties. Therefore. ICAI structure can replace the other transparent conducting material with a low annealing temperature and low energy.
15 May 2026 in Indian Journal of Physics