19 March 2008 in Journal of Engineering Materials and Technology
In rubber-blended polymer, the onset of cavitation in the particles relaxes the high triaxiality stress state and suppresses the onset of crazing in the polymer. As a result, large plastic deformation is substantially promoted compared with single-phase polymer. On the other hand, it is also well known that the onset of cavitation depends on the size of particle. To investigate the size dependence of cavitation behavior in the particle, a theoretical analysis is done employing a void model under plane strain condition, which takes into account the surface tension and the limiting stretch of the void. Continuously, to study the effect of the size-dependent cavitation on the micro- to macroscopic mechanical behavior of the blend, a computational model is proposed for the blend consisting of irregularly distributed heterogeneous particles containing the void with surface force. The results indicate that when the size of the particle decreases to a critical value that depends on both the initial shear modulus of particle and the surface tension on the surface of void, the increase of the critical stress for the onset of cavitation becomes remarkable and consequently, the onset of cavitation is eliminated. When the particle is embedded in polymer, the relation between average normal stress, which is acting on the interface of particle and matrix, and volumetric strain of particle shows dependence on the size of particle but no dependence on the triaxiality of macroscopic loading condition. For the blend consisting of particles smaller than the critical value, the onset of cavitation is eliminated in particles and as a result, the conformation of the shape of particle to the localized shear band in matrix becomes difficult and the shear deformation behavior tends to occur all over the matrix. Furthermore, in this case, the area of the maximum mean stress is confined to the area adjacent to the particle and the value of it increases almost linearly throughout the whole deformation process, which would lead to the onset of crazing in matrix. On the other hand, it is clarified that the onset of cavitation is predominant in the localized microscopic region containing heterogeneous particles and therefore, the plastic deformation is promoted in this region.
1 January 2003 in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
1 January 2005 in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
1 April 2002 in International Journal of Damage Mechanics
To clarify the mechanical characteristics and damage of polymers containingsecond-phase particles, i.e., blended polymers, a homogenization method has been developed which can handle the large deformation problems, including onset and propagation of instability, and completely reproduce the periodic feature of the distribution of second-phase particles under any macroscopically homogeneous loading condition. The parametric study has clarified the characteristic features of polymers containingperiodically distributed soft cylindrical particles of different volume fractions and sizes subjected to macroscopically homogeneous stress in different directions. The results indicate that, dependingon the tensional direction with respect to the unit cell, different types of shear bands are observed, and that the shear band connectingthe particles that appeared in the early stages of deformation is responsible for the reduction of the macroscopic yield stress. Increasingthe volume fraction of particles causes a decrease of the macroscopic yield stress and of the directional dependence of the macroscopic stress–strain relation. The size difference of particles causes very complicated and different types of shear bands, however, due to the high stress concentration caused by the presence of small particles, the onset and propagation of shear bands are promoted, and the macroscopic deformation behaviors become essentially isotropic. The maximum mean stress appears in the small particle, which suggests that the blending of particles of different sizes promotes the onset of cavitation, which suppresses the maximum mean stress in the matrix and results in additional shear deformation and in preventing onset of damage in matrix caused by crazing. The location of maximum normal stress on the boundary surface between particles and matrix moves with the propagation of the shear band. The magnitude of maximum normal stress increases with the increase of the size difference between the particles and with the decrease of the volume fraction within the present simulation.
1 January 2007 in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
1 January 2006 in TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A