This study presents a hybrid BRDF modeling framework combining a five-parameter physical model with a (20,20,20) Multilayer Perceptron (MLP) model network to address the critical challenge of accurate grazing-angle prediction for low-gloss black coatings (SB-3A, Z306, PNC). While the baseline parametric model achieves 1.2 RMSE at 80° incidence. The proposed MLP model-enhanced solution reduces these high-angle errors to <0.012 RMSE while maintaining <5-min computational efficiency. Comprehensive validation shows the framework’s universality across materials with apparent anisotropy indices (ASI) of 0.465–30.26. The work demonstrates that neural networks can optimally compensate for missing physics in traditional models without sacrificing interpretability, offering immediate industrial value for aerospace coating analysis.
To enable accurate evaluation of satellite laser communication terminals under solar outage interference, this paper presents the design and implementation of a solar radiation simulation system targeting the 1540–1560 nm communication band. The system reconstructs co-propagating interference conditions through standardized and continuously tunable output, based on high irradiance and spectral uniformity. A compound beam homogenization structure—combining a multimode fiber and an apodizator—achieves 85.8% far-field uniformity over a 200 mm aperture. A power–spectrum co-optimization strategy is introduced for filter design, achieving a spectral matching degree of 78%. The system supports a tunable output from 2.5 to 130 mW with a 50× dynamic range and maintains power control accuracy within ±0.9%. To suppress internal background interference, a BRDF-based optical scattering model is established to trace primary and secondary stray light paths. Simulation results show that by maintaining the surface roughness of key mirrors below 2 nm and incorporating a U-shaped reflective light trap, stray light levels can be reduced to 5.13 × 10−12 W, ensuring stable detection of a 10−10 W signal at a 10:1 signal-to-background ratio. Experimental validation confirms that the system can faithfully reproduce solar outage conditions within a ±3° field of view, achieving consistent performance in spectrum shaping, irradiance uniformity, and background suppression. The proposed platform provides a standardized and practical testbed for ground-based anti-interference assessment of optical communication terminals.
The rolling seal is a pivotal sealing technology for marine equipment such as wet-mateable connectors, ensuring operational integrity in deep-sea environments during both static and mating phases. However, its working mechanisms remain inadequately understood, and the effects of sealing parameters and seawater pressure have yet to be systematically studied. To address these issues, a refined model for rolling seals operating in deep-sea pressure-balanced conditions was developed. The model’s accuracy was enhanced by incorporating two key inputs: experimentally measured boundary lubrication friction coefficients (replacing conventional dry friction values) for finite element simulation and torque calculation, and oil pressure under pressure-balanced conditions, derived from shell theory, as a boundary load. Through systematic parametric simulations, the effects of interference fit, rotational speed, and seawater pressure on sealing performance were elucidated. An experimental torque test setup under atmospheric pressure was constructed to validate the numerical model. The results indicate that, while ensuring reliable static sealing, higher rotational speeds and smaller interference fits help reduce rotational torque. Benefiting from the pressure-balanced design, increasing water depth significantly enhances hydrodynamic performance—accounting for over 90% of the total static contact pressure at 1500 m—while leakage shows a decreasing trend. These findings provide theoretical insights for optimizing deep-sea sealing structures.