23 August 2024 in International Journal of Thermal Sciences
13 September 2013 in Journal of Turbomachinery
Thermomechanical stresses in gas turbine blades are investigated. Attention is focused on effects caused by varying the cooling airflow that runs through the blade interior, keeping constant a mainstream condition around the blade surface. Stress concentration was predicted numerically under engine real operating conditions. Temperature distributions in the metal blade surface produced by convective boundary conditions were linked with heat conduction within the blade using a conjugate solution. Results of stress concentration in the blade material for reduced cooling flow rate, blocked cooling ducts, and rotation rate were obtained. It is shown that temperature and stress distributions are a strong function of position in blade interior material and surface. Thermomechanical stress concentration was observed in the leading edge, with the endwall region affected by large stress concentration. Stress magnitude increments were found for combined cyclic thermal heating and sustained mechanical loads on specific planes of airfoil span for reduced cooling flow. Also, large stress gradients between leading and trailing regions of the blade were observed. The study reveals that blocking channels increase stresses in the central region of blade transversal cross section.
1 January 2014 in International Journal of Vehicle Design
The strain rate that takes place in the belts of tyres during automobile movement is proposed for converting mechanical energy into electricity. This paper describes how cyclic strain in tyres can be used for exciting piezoelectric materials placed in contact with the inner side of the tyre belt. Stress strain in tyre belts is caused by total mass weight in equilibrium with a pressurising condition. Under this condition, one section of the tyre in contact with the pavement deforms gradually until a maximum is reached, followed by a smooth release. The effect is continuous during each cycle of tyre rotation. Numerical simulations based on the finite element method were conducted for calculating the stress in composite materials that reproduce a combination of tyre belt piezoelectric polymer films. Results were obtained for different conditions of velocity and automobile total mass. The piezoelectric material was sectioned into elements that cover the entire belt interior, leading to continuous generation of electricity. The numerical simulations assumed that automobile speed varied from 0 to 113 km/hr, combined with mass increments from one to five passengers, for a constant inflation pressure. The results indicate that electric current generated by the strain-stress in tyres increases almost linearly as a function of weight and speed. The electricity generated in tyres can be used to recharge the batteries in hybrid and conventional cars. It can even lead to reductions of alternator capacity. This process is a function of travel distance as well, since harvesting of energy takes place every tyre cycle.
28 July 2014 in Desalination and Water Treatment
The hydrodynamics of an air–water flow in a column has been analyzed. The reactor consisted of a vertical column of 0.055 m diameter and 0.255 m height, made of acrylic to achieve good visualization of the bubbles. The column was partially packed with solid cylindrical pellets. The study was focused on the region above the packed zone in three vertical positions. Measurements of velocity in ascendant flow direction were conducted at each position using laser Doppler anemometry. Velocities along the column diameter were experimentally determined for two liquids flow, 300 and 600 L/h. Two conditions of Reynolds number were obtained, Re: 8.3 and 16.7 × 103 based on inlet pipe diameter and water properties. The results show that the size and shape of the bubbles become smaller and uniform when the column was packed. Experimental measurements of the velocity were difficult to determine when the Re was higher (Re > 17 × 103). Also, the velocity profile showed instability of the flow, mainly in the near packed region. However, an average value of the velocity could be observed as function of the inlet condition.