Transport and alignment of microscopic chips are important steps in microelectronics component integration with common approaches being pick‐and‐place, microfluidics, parallel transfer and self‐assembly. An alternate transport approach of microscopic chips is proposed using patterned liquid micro rails as chaperones. The surface free energy and interfacial free energy minimization of all constituents enable the creation of stable pathways. This allows for chip‐attachment to rails, while the liquid layer lubricates chip‐sliding. Monorails, digital monorails, and digital birails are investigated for chip movement behavior. Chip position and speed can be controlled using liquid flow in closed chambers. Speeds from 10 to 400 mm s −1 are achieved with translation distances as long as 50 mm. It is discovered that chips can selectively cross rail discontinuities of up to 500 µm, allowing for chip position control through a stop‐and‐go motion. A programmable liquid rails‐based chip conveyor system is demonstrated by transporting diodes to receptor sites where they undergo self‐assembly.
This communication demonstrates fluidic self‐assembly and self‐alignment of flip‐chips applying magnetic field force for chip agitation and single angular orientation. The receptor solder bumps are Pb‐free electroplated core and core‐shell metal layers with tailored transformation imprinted melting points. While the capturing step takes place on the low‐melting shell Bi33.7In66.3 (72 °C) of the capturing Cu‐pad, the high‐melting core tin on capturing as well as on non‐capturing Cu‐pad remains solid. The flip‐chips are provided with a nickel bar on top and are agitated over the substrate using magnetic field force in water as an assembly medium. The reduction of the free surface energy of the shell‐water interface provides the driving force for the capturing step in heated water. Once the capturing step on all shell receptors is completed, the external magnetic field causes the single angular orientation of the flip‐chips. A short reflow causes the transformation of the core and the shell in a high‐melting point solder on capturing receptors. Additionally, the formation of a solder joint between the core on the non‐capturing Cu‐pad and the corresponding Au‐binding side on the chip succeeds in the same reflow step yielding the second stable high melting interconnect of the flip‐chips to the substrate.