Coal contains cracks and has strong heterogeneity, so the data dispersion is large in laboratory tests. In this study, 3D printing technology is used to simulate hard rock and coal, and the rock mechanics test method is used to carry out the coal–rock combination experiment. The deformation characteristics and failure modes of the combination are analyzed and compared with the relevant parameters of the single body. The results show that the uniaxial compressive strength of the composite sample is inversely proportional to the thickness of the weak body and directly proportional to the thickness of the strong body. The Protodyakonov model or ASTM model can be used as a verification method for the results of a uniaxial compressive strength test of coal–rock combination. The elastic modulus of the combination is the equivalent elastic modulus, and the elastic modulus of the combination is between the elastic modulus of the two constituent monomers, which can be analyzed using the Reuss model. The failure of the composite sample occurs in the low-strength material, while the high-strength section is rebounding as an extra load on the low-strength body, which may cause a sharp increase in the strain rate of the weak body. The main failure mode of the sample with a small height–diameter ratio is splitting, and the failure mode of the sample with a large height–diameter ratio is shear fracturing. When the height–diameter ratio is not greater than 1, it shows pure splitting, and when the height–diameter ratio is 1~2, it shows a mixed mode of splitting and shear fracture. The shape has a significant effect on the uniaxial compressive strength of the composite specimen. For the impact propensity, it can be determined that the uniaxial compressive strength of the combination is higher than that of the single body, and the dynamic failure time is lower than that of the single body. It can hardly determine the elastic energy and the impact energy of the composite with the relationship to the weak body. The proposed methodology provides new cutting-edge test technologies in the study of coal and coal-like materials, with an exploration of their mechanical properties under compression.
Rock bursts and coal and gas outbursts are geodynamic disasters in underground coal mines. Laboratory testing of raw coal samples is the dominant research method for disaster prediction. However, the reliability of the experimental data is low due to the inconsistency of the mechanical properties of raw coal materials. The utilization of structural coal resources and the development of new coal-like materials are of significance for geodynamic disaster prediction and prevention. This paper studies the failure characteristics and dynamic disaster propensities of coal-like burst-prone briquettes under different gas pressures. A self-made multi-function rock–gas coupling experimental device was developed and burst-prone briquettes were synthesized, which greatly improved the efficiency and precision of the experimental data. The results showed that the burst proneness of the briquette was thoroughly reduced at a critical gas pressure of 0.4 MPa. When the gas pressure was close to 0.8 MPa, both the bearing capacity and the stored burst energy reduced significantly and the dynamic failure duration extended considerably, indicating the typical plastic-flow failure characteristics of coal and gas outbursts. The acoustic emission monitoring results showed that with the increase in gas pressure, the post-peak ringing and the AE energy ratio of coal samples increased, suggesting that the macroscopic damage pattern changed from bursting-ejecting of large pieces to stripping–shedding of small fragments adhered to mylonitic coal. In addition, the transformation and coexistence of coal failure modes were discussed from the perspectives of coal geology and gas migration. This study provides a new method for the scientific research of compound dynamic disaster prevention in burst coal mines with high gas contents.