C. Garcıa Ceballos

C. Garcıa Ceballos

Auto-generated profile, based on publicly available information

C. Garcıa Ceballos

Department of Electric Power Engineering

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 April 2023 in International Journal of Electrical Power & Energy Systems
Verified
Journal Article
Closed access
CGC. García-Ceballos
C. García-Ceballos
SPS. Pérez-Londoño
S. Pérez-Londoño
JMJuan Mora-Florez
Juan Mora-Florez

11 April 2022 in International Transactions on Electrical Energy Systems
Verified
Journal Article
Open access
PDF file
CGC. García-Ceballos
C. García-Ceballos
SPSandra Perez-Londoño
Sandra Perez-Londoño
JMJuan Mora-Florez
Juan Mora-Florez
This paper proposes an iterative approach to adjust the control parameters of multiple power converters within a microgrid, which operates in grid-connected and grid-islanded modes. The adequate control parameters are determined using an optimisation-based strategy, local measurements, and results obtained in previous algorithm iterations. The proposed objective function is based on the integral time-weighted absolute error (ITAE), modified to improve the microgrid control performance. The proposed approach addresses the control tuning complexity by considering an incremental strategy, starting from adjusting basic microgrids, continuing to the setting of intermediate microgrids, and finalising when the target microgrid control is fine adjusted. The results obtained at the CIGRE LV benchmark microgrid validate the proposal, obtaining during faults, the maximum deviations from rated frequency around 2.2% and 0.3% in grid-islanded or grid-connected cases, respectively. Also, voltage and power references are adequately followed during steady-state regardless of the microgrid operation mode, where the steady voltage profile is below 10% variation. The obtained results demonstrate the proposed approach advantages, which straightforwardly adjust multiple converters integrated into a microgrid. The main contributions are as follows: (a) the microgrid model is not required, and (b) only measurements at the point of common coupling of the distributed energy resource are used; consequently, the proposed tuning approach is especially applicable to complex microgrids. Finally, finely adjusted microgrids are required for further operation or protection studies where complex system configurations are commonly required.

12 June 2024 in Ain Shams Engineering Journal
Verified
Journal Article
Open access
CGC. García-Ceballos
C. García-Ceballos
SPS. Pérez-Londoño
S. Pérez-Londoño
JMJ. Mora-Flórez
J. Mora-Flórez

1 January 2022 in SSRN Electronic Journal
Verified
Preprint
Open access
PDF file
JMJuan Mora-Florez
Juan Mora-Florez
CCC. Garcıa Ceballos
C. Garcıa Ceballos
SPSandra Perez-Londoño
Sandra Perez-Londoño
Electric distribution networks are experiencing fast changes due to the inclusion of distributed energy resources (DERs). These changes originate active distribution networks (ADNs), where several DERs are integrated, frequently using power converters. In ADN, the conventional control, operation, and protection schemes used in power systems are unsuitable; new approaches must be proposed and tested. This paper analyses the distance relay performance in ADNs, and as the main contribution, a communication−less compensation strategy is proposed to deal with the effects of fault resistance and the DERs infeed and remote currents. The obtained results demonstrate the excellent performance of the proposed compensation strategy aimed at determining the true value of the estimated positive sequence impedance. This compensation can be easily integrated into the software of conventional distance relays to overcome fault resistance, infeed, and remote current effects.