Mohammad Akbari

Mohammad Akbari

Auto-generated profile, based on publicly available information

Mohammad Akbari

Department of Electrical and Computer Engineering, University of Waterloo, Waterloo, ON N2L 3G1, Canada

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 April 2017 in IEEE Access
Verified
Journal Article
Open access
MAMohammad Akbari
Mohammad Akbari
HGHamdan Abo Ghalyon
Hamdan Abo Ghalyon
MFMohammadmahdi Farahani
Mohammadmahdi Farahani
ASAbdel-Razik Sebak
Abdel-Razik Sebak
TDTayeb A. Denidni
Tayeb A. Denidni
In this paper, an effective approach for mitigating the near-field coupling between four-port circularly polarized (CP) antennas in a 30-GHz multiple-input, multiple-output (MIMO) system is suggested and investigated. This is obtained by incorporating a two-layer transmission-type frequency selective surface (FSS) superstrate based on planar crossed-dipole metal strips. This paper presents a comparison between the mutual coupling when the patches are radiating in free space and in the presence of the FSS layers. The simulated results, when the FSS layers are applied, show an average of 6-12-dB improvement in the isolation between four adjacent CP-MIMO antennas. In addition, an accurate study is carried out on the insignificant reflections produced by the FSS layers to redirect those and also prevent any interference. The proposed 2 x 2 CP-MIMO antenna along with the superstrate is implemented and tested to validate the simulation results. Experimental results of the coupling and reflection coefficients and axial ratio show an acceptable agreement with the corresponding simulated ones.

1 November 2016 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
MAM. Akbari
M. Akbari
SGShraman Gupta
Shraman Gupta
MFMohammadmahdi Farahani
Mohammadmahdi Farahani
ASAbdel R. Sebak
Abdel R. Sebak
TDTayeb A. Denidni
Tayeb A. Denidni
In this article, a high gain circularly-polarized (CP) dielectric resonator antenna (DRA) is proposed. The radiating DR is coupled to a 50Ω microstrip line through an X-shaped slot etched off the common ground plane. Using a frequency selective surface (FSS) superstrate layer, a gain enhancement of 8.5 dB is achieved. A detailed theoretical analysis is given and used to optimize the superstrate size and the air gap height between the antenna and superstrate layer. The proposed DRA is designed, simulated, implemented, and tested. The high gain CP DRA has the potential to be used for millimeter wave (MMW) wireless communication and imaging systems.

16 October 2018 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
SZSaman Zarbakhsh
Saman Zarbakhsh
MAMohammad Akbari
Mohammad Akbari
FSFereshteh Samadi
Fereshteh Samadi
ASAbdel Sebak
Abdel Sebak
In this paper, a wideband circularly polarized (CP) antenna with low radar cross-section (RCS) and high gain properties is investigated. The proposed antenna is based on a combination of the Fabry-Perot cavity (FPC) and sequential feeding technique. The purpose of this antenna is to produce CP with high directive gain over a wide bandwidth, whilst preserving low RCS. The principle of the FPC and resonance is achieved by applying one frequency selective surface (FSS) metasurface. A microstrip slot array operating at the Ka-band, excited by a sequentially rotated feeding network is designed and fabricated. It is indicated that all the merits mentioned above can be obtained over a broad frequency band by designing a suitable FSS metasurface and modifying the feeding lengths to adjust desirable phase. RCS reduction is realized by 180° + 37° reflection phase variations between adjacent FSS unit cells on the metasurface. The experimental results show that the gain of the antenna with the metasurface is at least 7 dB greater than that of the primary antenna with a peak value approximately 20 dB at 28.5 GHz. In addition, bandwidths of 3-dB gain, impedance (|S11| ≤ -10 dB), and axial ratio (AR) ≤ 3 dB are ranged from 27.5 to 33.5 GHz (19.7%), 26.7 to 34.2 GHz (24.6%) and 26.8 to 33.1 GHz (21%), respectively. The monostatic RCS reduction for a normal incidence is effectively suppressed from 28 to 48 GHz (52%).

6 September 2019 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
SZSaman Zarbakhsh
Saman Zarbakhsh
MAMohammad Akbari
Mohammad Akbari
MFMohammadmahdi Farahani
Mohammadmahdi Farahani
Alireza GhayekhlooAlireza Ghayekhloo
Alireza Ghayekhloo
TDTayeb A. Denidni
Tayeb A. Denidni
ASAbdel Sebak
Abdel Sebak
This manuscript focuses on the design of a transparent circularly polarized (CP) antenna subarray integrating with CubeSat’s solar panels. The sub-array antenna employs two techniques including the Fabry_Perot cavity (FPC) and sequential rotation-feeding network. These techniques are used to generate CP along with a high level of directivity over a broad bandwidth. The main aim here is to propose a multi-functional antenna with the high radiation properties as well as the capability of power harvesting, simultaneously. To harvest power using a solar panel the transparency requirement should be satisfied. Hence, the proposed design is sputtered with the thin layer of indium-tin-oxide (ITO) with a thickness of 200nm. However, it seems to be sacrificed a large amount of conductivity at the frequency band of interest (x-band). Correspondingly, the performance of conductivity and transparency both the materials of ITO and copper as coated on the proposed design is determined. Alternatively, as an optically transparent conductor (OTC), a combination of both coating layers, including ITO and copper with thicknesses of 200nm and 5nm, respectively, are applied. In the scattering point of view, the proposed design is also capable of suppressing the radar cross section (RCS) for the space missions with the aim of space-based observations.

26 October 2018 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
MAMohammad Akbari
Mohammad Akbari
AFAli Farahbakhsh
Ali Farahbakhsh
ASAbdel Sebak
Abdel Sebak
This paper proposed a wideband, efficient and high gain circularly polarized (CP) array antenna based on gap waveguide technology for 30 GHz frequency band applications. The antenna sub-array is a 2 ×2-slot groove gap waveguide (GGW)-based cavity-backed antenna. The antenna is fed by a ridge gap waveguide (RGW). Two corners of the radiating slots are truncated to obtain CP radiation and some corrugations are introduced to the radiating layer to suppress the surface waves between neighbor sub-arrays. The planar 16-way feeding network based on RGW is utilize to feed the sub-arrays. The feeding network is multi-level sequential phased with a quadrature phase shift. To validate the array antenna performance, a prototype of the antenna has been manufactured using standard milling technology. The measured reflection coefficient bandwidth is about 22 % covering from 28.3 to 35.3 GHz and a measured 3-dB axial ratio bandwidth of about 21.8 % is achieved from 27.8 to 34.6 GHz. The maximum measured gain is 23.5 dBi which is occurred at 30.75 GHz.

22 February 2019 in IEEE Antennas and Propagation Magazine
Verified
Journal Article
Closed access
MAMohammad Akbari
Mohammad Akbari
FSFereshteh Samadi
Fereshteh Samadi
ASAbdel Sebak
Abdel Sebak
TDTayeb A. Denidni
Tayeb A. Denidni