Mingyu Li

Mingyu Li

Auto-generated profile, based on publicly available information

Mingyu Li

College of Mechanical and Electrical Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing, China

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 December 2025 in IEEE/ASME Transactions on Mechatronics
Verified
Journal Article
Closed access
DWDelan Wei
Delan Wei
PLPengcheng Li
Pengcheng Li
RSRunda Sun
Runda Sun
XWXuewen Wei
Xuewen Wei
MLMingyu Li
Mingyu Li
TWtian wei
tian wei
Industrial robots are widely used due to their high flexibility and cost-effectiveness; however, the precision limitations hinder their applications in mechanical processing. A critical factor affecting precision is the joint transmission system, where error sources such as nonlinearity, backlash, and radial clearance remain insufficiently addressed. Based on mechanistic analysis and test validation of the residual errors after secondary encoder system (SES) compensation, this study proposes a composite control strategy that integrates SES feedback with crosstalk compensation to address dynamic disturbances. The approach begins with joint detection using high-precision gratings, establishing an angular measurement error compensation model to correct SES measurement errors. Subsequently, feedforward control is implemented based on the crosstalk error model to mitigate the impact of axis-to-axis crosstalk and joint radial clearance on end-effector positioning accuracy. Finally, experimental results demonstrate a significant enhancement in robotic accuracy, achieving multidirectional repeatability of $\pm$0.08 mm and circular trajectory accuracy of $\pm$0.2 mm. This study effectively addresses flexible deformation caused by rotational and radial clearances, enhancing robot positioning accuracy through an innovative crosstalk compensation mechanism and providing a novel solution for high-precision robotic machining.

10 November 2026 in IEEE Robotics and Automation Letters
Verified
Journal Article
Closed access
MLMingxuan Liu
Mingxuan Liu
PLPengcheng Li
Pengcheng Li
KWKe Wang
Ke Wang
MLMingyu Li
Mingyu Li
TWtian wei
tian wei
YMYunfei Miao
Yunfei Miao

31 October 2025 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
DWDelan Wei
Delan Wei
PLPengcheng Li
Pengcheng Li
TWtian wei
tian wei
MLMingyu Li
Mingyu Li
YMYunfei Miao
Yunfei Miao
RSRunda Sun
Runda Sun
Carbon fiber reinforced plastics (CFRP) are widely used in aerospace components, and trimming is an essential process in their manufacturing. In the trimming process, robots are increasingly employed due to their flexibility, cost-effectiveness and extensive processing range. A critical factor that directly affects the geometric accuracy in CFRP parts trimming is the contour error. However, the multisource errors of robots lead to processing contour accuracy defects, especially for free-form nonparametric splines and continuous paths. This article proposes a switching geometrical relations real-time contour error estimation technique. A projection ratio is introduced to improve the solution accuracy of contour error. Subsequently, a double-loop cascade contour error control method based on singular perturbation techniques is proposed. The inner loop utilizes a secondary encoder to compensate for joint flexibility by tracking control, while the outer loop is based on contour error estimation to implement pose correction control in Cartesian space for the desired contour. The estimation and control methods were validated by continuous pentagonal and space S curve paths. The results reveal that the discrepancies of contour error estimation are small within 0.03 μm and calculation time is less than 0.1 ms. The contour error is less than ±0.17 mm, representing a 90% improvement.