This paper presents the relationship among stress, crystallographic texture, and soft magnetic properties of thin films. The magnetic properties considered are those affected by the formation of stripe domains and by the formation of magnetization ripple. In practice, one of these two undesirable domain structures is almost always the impediment to improving the soft magnetic properties. The theoretical analysis accounts for the contribution from stress through magnetostrictive anisotropy, and calculates the resulting total, stress-dependent anisotropy of the film. This anisotropy is then analyzed to yield the effective perpendicular and local in-plane anisotropy constants. These constants allow the calculation of the stripe domain onset thickness through Murayama's stripe domain theory, and the ripple coercivity through Hoffmann's ripple theory. The influence of stress and texture on the stripe domain onset thickness and ripple coercivity is theoretically calculated and experimentally verified for the examples of sputtered CoFe and FeAlN films, two of the most promising and widely studied materials for high-density recording head poles. The results indicate that the interactions between stress and soft magnetic properties depend on the details of composition, growth texture, growth morphology (whether the film is grown in columnar fashion or as equiaxial crystallites), grain size, and thickness of the film under consideration. On the basis of these results, the paper offers a systematic approach to choosing the appropriate composition, texture, and thickness so that low stresses simultaneously promote magnetic states in which stripe domains are suppressed and coercivities are low. The calculations presented here can be easily extended to other aspects of soft magnetic properties addressed by the ripple theory, such as initial permeability.
Capacitance−voltage characteristics of high quality Pt Schottky diodes fabricated on oxygen-vacancy-doped SrTiO3 single crystals were used to obtain the oxygen vacancy profiles within one microns of the Pt interface. Computer simulations based on solving the drift-diffusion equations for electrons and ionized vacancies were performed to understand the experimentally observed oxygen vacancy profile’s time-evolution at room temperature and 0 V applied bias. Building upon this understanding, the diode’s room temperature profile evolution under −35 V applied bias was analyzed to yield a vacancy mobility value of 1.5 × 10−13 cm2/V·s at an electric field of 500 kV/cm. This mobility is 8 orders of magnitude too low to produce nanosecond resistance switching in thin film devices. The applicability of the results to oxygen-migration-based resistance switching is discussed relative to recent observations and modeling.
This article describes an approach for implementing a complete computer system (CPU, RAM, I/O, and nonvolatile mass memory) on a single integrated-circuit substrate (a chip)—hence, the name “single-chip computer.” The approach presented combines advances in the field of microelectromechanical systems (MEMS) and micromagnetics with traditional low-cost very-large-scale integrated circuit style parallel lithographic manufacturing. The primary barrier to the creation of a computer on a chip is the incorporation of a high-capacity [many gigabytes (GB)] re-writable nonvolatile memory (in today’s terminology, a disk drive) into an integrated circuit (IC) manufacturing process. This article presents the following design example: a MEMS-based magnetic memory that can store over 2 GB of data in 2 cm2 of die area and whose fabrication is compatible with a standard IC manufacturing process.
We present a measurement technique for performing spatially resolved ferromagnetic resonance and directly imaging quantized magnetostatic modes in magnetic samples that undergo high frequency magnetic drive fields (up to 8 GHz). The dynamic response of a permalloy structure (100 nm thick) under a 7.04 GHz highly nonuniform drive field was measured as a function of the dc bias field using this technique. The magnetization variation observed indicates that quantized magnetostatic mode waves appear at certain bias fields, with the number of nodes decreasing with an increase in the bias field. We tentatively assign the indices of each mode using the Damon–Eshbach (DE) model. Similar modes have been observed for a similar sample geometry using an inductive measurement and they showed good agreement with the DE model. However, the result measured using this technique showed some discrepancy with the DE model and the spatial patterns observed are more complicated than simple one-dimensional standing waves. This complexity suggests that analysis beyond that of the DE model is required to explain the observations.