Yury V. Taran

Yury V. Taran

Auto-generated profile, based on publicly available information

Yury V. Taran

Joint Institute for Nuclear Research

Research Focus & Metrics

Academic Career Length

64Years (1963-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2013 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
YTYury Taran
Yury Taran
ABA.M. Balagurov
A.M. Balagurov
BSBasar Sabirov
Basar Sabirov
VDVadim Davydov
Vadim Davydov
AVAndrew Venter
Andrew Venter
Recently, reliable and hermetic joining of stainless steel to niobium pipes has been achieved with the explosive bonding technique. Joining of these two materials are essential to ensure production of a bimetallic transition element of pipe-type for its further use as a part of charged beam acceleration systems of the new generation. A non-destructive neutron diffraction investigation of the tri-axial strains along a radial cross-sectional line through the joint section has been performed. Residual stress results indicate inherently different natures in the residual stress values within the respective pipe sections. In the external stainless steel pipe the residual stresses are tensile, showing a sudden increase to 600 MPa as the interface is approached, whilst being compressive in the internal niobium pipe, not exceeding 650 MPa. A characteristic abrupt stress discontinuity exits at the interface region.

15 September 2006 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
YTYu. V. Taran
Yu. V. Taran
JSJuergen Schreiber
Juergen Schreiber
MDMark R. Daymond
Mark R. Daymond
EOE.C. Oliver
E.C. Oliver
On ECRS-6 [1], we have presented first results of the researches of fatigue degradation and martensitic transformation of austenitic stainless steel AISI 321 by neutron diffraction stress analysis. A series of samples preliminary ex-situ cyclically fatigued at the frequency of 5 and 0.5 Hz was in-situ tested on the stress rig of the ENGIN instrument. In the high cycle fatigued (HCF) samples, the applied stress-elastic strain responses of austenite and martensite phases were find out to be strongly different as compared to the low cycle fatigued (LCF) samples, in which they are close. Moreover, the martensite Poisson ratio in the HCF-samples is almost twice to that of observed 0.28-0.30 in austenite and in both phases of the LCF-samples. With the purpose to search the reason of such unusual behavior of the martensite phase, one of the HCF-samples has been anew in-situ tested on the stress rig of the ENGIN-X in: 1) a LCF-mode at the frequency of 0.1 Hz to increase the fatigue level, and 2) a quasistatic mode to measure the applied stress-elastic strain responses of both phases. Also, two of the LCF-samples have been subjected to the ex-situ secondary HCF-testing at the frequency of 5 Hz and again in-situ measured on the ENGIN-X stress rig. Results of the mechanical characterization of phases in the twice fatigued austenitic stainless steel are presented and discussed.

21 April 1998 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
YTYu. V. Taran
Yu. V. Taran
JSJuergen Schreiber
Juergen Schreiber

21 May 2000 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
YTYu. V. Taran
Yu. V. Taran
JSJuergen Schreiber
Juergen Schreiber
PMPavol Mikula
Pavol Mikula
PLPetr Lukáš
Petr Lukáš
DND. Neov
D. Neov
MVMiroslav Vrána
Miroslav Vrána

1 March 2008 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
YTYu. V. Taran
Yu. V. Taran
ABA.M. Balagurov
A.M. Balagurov
JSJuergen Schreiber
Juergen Schreiber
Alexander KorsunskyAlexander Korsunsky
Alexander Korsunsky
An ex-situ in-plane biaxial low cycle fatigued sample of cruciform geometry made from austenitic stainless steel AISI 321 H was studied with the help of neutron diffraction strain scanning and also in-situ uniaxial loading using a stress rig on the FSD stress-diffractometer at the IBR-2 pulsed nuclear reactor (Dubna). The objectives of the experiment were to measure the macroscopic and microscopic residual stresses, crystallographic phase composition and the mechanical characteristics of the alloy under fatigue conditions. To the best of our knowledge, no neutron diffraction investigations of structural alloys subjected to biaxial loading have previously been reported. Experimental data interpretation and analysis are presented and discussed.

1 July 1994 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
ABA.M. Balagurov
A.M. Balagurov
VSV.G. Simkin
V.G. Simkin
YTYu. V. Taran
Yu. V. Taran