Aerodynamic stability and buffeting response due to turbulent wind have a fundamental importance for long-span bridge design. However, there are no benchmark cases that can be used as a reference estimate for an independent validation of the numerical methods and theoretical approximations. Therefore, the IABSE Task Group 3.1 proposal is to fill this gap by defining a reasonably well predicted set case for the response to wind of long-span bridges, both in terms of aerodynamic stability and buffeting. Specifically, a statistical analysis was performed on the numerical results collected by the task group participants, who used their own methodology and tools (either in time domain and/or frequency domain) to predict the bridge stability to flutter and buffeting response to wind, sharing the same input data (wind conditions, bridge structural properties, and deck aerodynamic coefficients). The benchmark results presented in this paper can be used as a point of reference for other numerical codes, and they include the onset of flutter speed, damping ratio variation with mean wind speed and the root mean square of the displacements as a function of mean wind speed, power spectral density values, and time histories of displacements.
13 September 2021 in Structural Engineering International
A custom-made monitoring system for long-term measurements of the wind field, surface pressures and structural response has been installed on the Gjemnessund Bridge in Norway. The monitoring system has been operating from 2018 to 2021. The scope was to investigate several topics within bridge aerodynamics in a full-scale environment, e.g. vortex shedding, gust response and span-wise correlations. Six cross-sectional strips with pressure taps were installed on the bridge. The pressure strips covered a span-wise distance equal to approximately six times the deck width. The upstream and the wake flow properties were measured in five locations along the same span. A case study showed that the ten-second gust correlations were stronger than the ten-minute correlations, both span-wise and section-wise. The gust impact on the bridge caused peak-to-peak mid-span amplitudes of 1 m vertically and 2 m laterally.
The present paper investigates the possibilities for avoiding classical flutter and static divergence for very long-span suspension bridges with a novel, flexible, and lightweight triple-box girder. Previous studies have shown that the critical classical flutter wind speed tends to decline with the main span width. Other studies have shown that flutter can be avoided if the torsional frequency is lower than the vertical. The road to get there in practice, however, is complicated. The possibility for tuning the torsional natural frequency without affecting the vertical frequency is used in the present paper. The effect on aerodynamic stability is analyzed in detail for low torsional-to-vertical frequency ratios typical for very long-span bridges with lightweight and flexible girders. The present study includes nonlinear finite-element analysis and static, free vibration and forced motion wind tunnel tests. Aerodynamic stability has been obtained in a section model test with a lightweight setup corresponding to a bridge girder mass of only 6.38 t/m in full scale. Flutter was not observed for any torsional-to-vertical frequency ratios in the range from . Stability was observed up to wind speeds of approximately 88 m/s in full scale for a 2,125.2-m span. The aerodynamic stability obtained in the configurations of the present section at shows that this might be an economically feasible solution for future long-span suspension bridges because aerodynamic stability is achieved even though the torsional stiffness and the mass of the deck are low.