26 August 2022 in Physical Review Materials
Rutile-structured germanium oxide , an ultrawide band-gap (UWBG) semiconductor, is a promising candidate for future high-power electronics because of its excellent properties, including ambipolar dopability, high carrier mobilities, and a higher thermal conductivity than . In this paper, focusing on a wide variety of its applications, we propose an UWBG alloy system based on and other rutile-structured oxides and clarify the electronic structure and electrical properties based on experiments and the first-principles calculations. Experimentally, (001)-oriented alloy thin films with an entire range of Ge compositions were grown by a mist chemical vapor deposition technique. Structural characterizations show that the fabricated alloy films with and the well-crystallized part of the film with have uniform chemical compositions and the same epitaxial relations with (001) substrates. Transmission electron microscopy observations reveal that there are few dislocations in because of relatively small in-plane lattice mismatch. In contrast, many dislocations are observed near the film/substrate interface in . Lattice constants of the alloys both along the and axes decrease with increase in Ge compositions. Their band gaps were determined by spectroscopic ellipsometry analysis, indicating that the band gaps increase as Ge compositions increase with a bowing parameter of 1.2 eV. The values of lattice constants and the trend of band-gap transitions obtained by calculations are in good agreement with those of experimentally obtained each other. Then we presented the calculated natural band alignments of and alloys, suggesting the possibility of -type doping in and Ge-rich and availability of and Si-rich as a blocking layer of other rutile-structured devices. Finally, electrical measurements demonstrated -type conductivities in .
20 April 2021 in Japanese Journal of Applied Physics
Recently, α -Ga 2 O 3 has been attracting great attentions as a new wide bandgap semiconductor, however, the reason why metastable α -Ga 2 O 3 is grown by mist chemical vapor deposition (CVD) has not been understood. In this study, in order to elucidate growth mechanism of mist CVD-grown α -Ga 2 O 3 , growth processes in the initial stage were investigated by atomic force microscopy, transmission electron microscopy, and X-ray diffraction reciprocal space mapping. We found that the characteristics of mist CVD make the relaxation mechanisms of α -Ga 2 O 3 on (0001) sapphire different from those of molecular beam epitaxy, pulsed-laser deposition, and metalorganic chemical vapor deposition. We also proposed the growth procedure in the initial stage.
27 September 2021 in Applied Physics Letters
Temperature dependencies of optical reflectance and cathodoluminescence (CL) spectra were measured for the MgO single crystal using a custom-built vacuum ultraviolet (VUV) spectroscopic system. Simultaneous observation enabled us to identify free exciton (FE) and bound exciton (BE) emissions by comparing the CL emission with the exciton resonance structures. The results indicated that the BE emission dominates the near-band edge emission, and the FE emission was observed as a shoulder at 300 K. The results ensure strong excitonic nature and potential of a rock salt-structured MgO-based material system for an active element in the VUV light emitter.
12 August 2018 in Physica Status Solidi (a)
14 April 2020 in Scientific Reports
To improve thermoelectric performance of materials, the utilization of low-dimensional materials with a multi-alloy system is a promising approach. We report on the enhanced thermoelectric properties of n-type Bi2(SexTe1−x)3 nanoplates using solvothermal synthesis by tuning the composition of selenium (Se). Variation of the Se composition within nanoplates is demonstrated using X-ray diffraction and electron probe microanalysis. The calculated lattice parameters closely followed Vegard’s law. However, when the Se composition was extremely high, an impurity phase was observed. At a reduced Se composition, regular-hexagonal-shaped nanoplates with a size of approximately 500 nm were produced. When the Se composition was increased, the shape distribution became random with sizes more than 5 μm. To measure the thermoelectric properties, nanoplate thin films (NPTs) were formed on a flexible substrate using drop-casting, followed by thermal annealing. The resulting NPTs sufficiently adhered to the substrate during the bending condition. The electrical conductivity of the NPTs increased with an increase in the Se composition, but it rapidly decreased at an extremely high Se composition because of the presence of the impurity phase. As a result, the Bi2(SexTe1−x)3 NPTs exhibited the highest power factor of 4.1 μW/(cm∙K2) at a Se composition of x = 0.75. Therefore, it was demonstrated that the thermoelectric performance of Bi2(SexTe1−x)3 nanoplates can be improved by tuning the Se composition.
1 December 2020 in AIP Advances
We presented a simple estimation method for band alignment of semiconductor alloys based on the atomic solid-state energy (SSE) scale. Our method has the advantage that natural band alignment can be determined using the SSE and energy gap of materials. We investigated several examples of the valence band offset and conduction band offset for β- related heterostructures, and our results were in good agreement with previous experimental data. These results indicated that simple and practical prediction of the band offset and alignment of ionic bonded semiconductors can be attained.