Sequential periodate–chlorite (PC) oxidation has been optimized stoichiometrically according to the non-crystalline content in cellulose to generate a variety of versatile C2,C3 dialdehyde/dicarboxylate nanocelluloses (NCs) while economizing chemical and shear force inputs. The robust primary sodium periodate (NaIO4) oxidation not only regioselectively cleaved the C2–C3 carbon bond to oxidize the vicinal hydroxyls to aldehydes, but also governed the lengths of NCs, i.e., cellulose nanofibrils (PC-CNFs) at near-equal NaIO4 to non-crystalline anhydroglucose unit (AGU) stoichiometry and cellulose nanocrystals (PC-CNCs) at a doubled ratio. Secondary sodium chlorite (NaClO2) oxidation facilely converted C2,C3 dialdehydes to dicarboxylates and, upon deprotonation, facilitated defibrillation to NCs, irrespective of extents of carboxylation or charges. The optimal 0.5 : 1 NaIO4/AGU and 1 : 1 NaClO2/AGU oxidation produced highly uniform 1.26 nm thick, 3.28 nm wide, and ca. 1 μm long PC-CNFs with tunable surface aldehyde (0.71–0.0 mmol g−1) and carboxylate (0.64–1.35 mmol g−1) content at 94–98% yields. The C2–C3 glucosidic ring opening and oxidation along the 110 or 10 crystalline surfaces increased the heterogeneity of the hydrophilic surfaces and flexibility of PC-CNFs to influence their self-assembling into fibrils and amphiphilic superabsorbent aerogels. The ultra-light (ρ = 10.3 mg cm−3) aerogels showed an ultra-high dry specific compression modulus (50.2 kPa mg−1 cm−3) and specific stress (8.2 kPa mg−1 cm−3 at 0.8 strain), cyclic wet compressive behavior, and excellent water-activated shape recovery following 0.8 strain dry compression.
Sustainable agriculture calls for the development of eco-friendly materials that possess desired properties and functionalities. In this study, the effect of incorporating lignin-grafted poly(ε-caprolactone) (LN-PCL) into a PCL matrix was evaluated. LN-PCL was synthesized by ring-opening polymerization (ROP), yielding polymers with varying PCL degrees of polymerization (DP 26–101) and amphiphilic properties. Incorporating LN-PCL into PCL films enhanced hydrogen bonding, crystallinity, and doubled Young’s modulus. SEM analysis showed smoother surfaces with higher DPs, while lower DPs reduced the contact angle from 78° to 68°. LN-PCL films absorbed >98% UVAB and >94% UVC light regardless of DP and degraded within 30 days. Release studies indicated controlled release rates of ATZ (<16%) and MTZ (46%) over 10 weeks. Overall, the UV protection, surface, mechanical, and controlled release properties of the LN-PCL/PCL films support the potential of these films as a carrier for chemicals with applicability in agriculture.